[dpdk-dev] [PATCH v2 2/2] mbuf: assign valid bit values for some RX and TX flags

[Zhang, Helin]

OK. I will send out another patch according to your comments. Thanks a lot!

Regards,
Helin

> -----Original Message-----
> From: Ananyev, Konstantin
> Sent: Friday, December 5, 2014 6:50 PM
> To: Zhang, Helin; dev at dpdk.org
> Cc: Cao, Waterman; Cao, Min; Wu, Jingjing; Liu, Jijiang;
> olivier.matz at 6wind.com
> Subject: RE: [PATCH v2 2/2] mbuf: assign valid bit values for some RX and TX
> flags
> 
> Hi Helin,
> 
> > -----Original Message-----
> > From: Zhang, Helin
> > Sent: Friday, December 05, 2014 1:46 AM
> > To: dev at dpdk.org
> > Cc: Cao, Waterman; Cao, Min; Wu, Jingjing; Liu, Jijiang; Ananyev,
> > Konstantin; olivier.matz at 6wind.com; Zhang, Helin
> > Subject: [PATCH v2 2/2] mbuf: assign valid bit values for some RX and
> > TX flags
> >
> > Before redefining mbuf structure, there was lack of free bits in
> > 'ol_flags' (32 bits in total) for new RX or TX flags. So it tried to
> > reuse existant bits as most as possible, or even assigning 0 to some
> > of bit flags. After new mbuf structure defined, there are quite a lot
> > of free bits. So those newly added bit flags should be assigned with
> > correct and valid bit values, and getting their names should be
> > enabled as well. Note that 'RECIP' should be removed, as nowhere will
> > use it.
> >
> > Signed-off-by: Helin Zhang <helin.zhang at intel.com>
> > ---
> >  lib/librte_mbuf/rte_mbuf.c |  9 ++++-----  lib/librte_mbuf/rte_mbuf.h
> > | 19 +++++++++----------
> >  2 files changed, 13 insertions(+), 15 deletions(-)
> >
> > v2 changes:
> > * Removed error flag of 'ECIPE' processing only in mbuf. All other error flags
> >   were added back.
> > * Assigned error flags with correct and valid values, as their previous values
> >   were invalid.
> > * Enabled getting all error flag names.
> >
> > diff --git a/lib/librte_mbuf/rte_mbuf.c b/lib/librte_mbuf/rte_mbuf.c
> > index 87c2963..3ce7c8d 100644
> > --- a/lib/librte_mbuf/rte_mbuf.c
> > +++ b/lib/librte_mbuf/rte_mbuf.c
> > @@ -210,11 +210,10 @@ const char *rte_get_rx_ol_flag_name(uint64_t
> mask)
> >  	case PKT_RX_FDIR: return "PKT_RX_FDIR";
> >  	case PKT_RX_L4_CKSUM_BAD: return "PKT_RX_L4_CKSUM_BAD";
> >  	case PKT_RX_IP_CKSUM_BAD: return "PKT_RX_IP_CKSUM_BAD";
> > -	/* case PKT_RX_EIP_CKSUM_BAD: return "PKT_RX_EIP_CKSUM_BAD"; */
> > -	/* case PKT_RX_OVERSIZE: return "PKT_RX_OVERSIZE"; */
> > -	/* case PKT_RX_HBUF_OVERFLOW: return "PKT_RX_HBUF_OVERFLOW";
> */
> > -	/* case PKT_RX_RECIP_ERR: return "PKT_RX_RECIP_ERR"; */
> > -	/* case PKT_RX_MAC_ERR: return "PKT_RX_MAC_ERR"; */
> > +	case PKT_RX_EIP_CKSUM_BAD: return "PKT_RX_EIP_CKSUM_BAD";
> > +	case PKT_RX_OVERSIZE: return "PKT_RX_OVERSIZE";
> > +	case PKT_RX_HBUF_OVERFLOW: return "PKT_RX_HBUF_OVERFLOW";
> > +	case PKT_RX_MAC_ERR: return "PKT_RX_MAC_ERR";
> >  	case PKT_RX_IPV4_HDR: return "PKT_RX_IPV4_HDR";
> >  	case PKT_RX_IPV4_HDR_EXT: return "PKT_RX_IPV4_HDR_EXT";
> >  	case PKT_RX_IPV6_HDR: return "PKT_RX_IPV6_HDR"; diff --git
> > a/lib/librte_mbuf/rte_mbuf.h b/lib/librte_mbuf/rte_mbuf.h index
> > 2e5fce5..c9591c0 100644
> > --- a/lib/librte_mbuf/rte_mbuf.h
> > +++ b/lib/librte_mbuf/rte_mbuf.h
> > @@ -84,11 +84,6 @@ extern "C" {
> >  #define PKT_RX_FDIR          (1ULL << 2)  /**< RX packet with FDIR
> match indicate. */
> >  #define PKT_RX_L4_CKSUM_BAD  (1ULL << 3)  /**< L4 cksum of RX pkt.
> is
> > not OK. */  #define PKT_RX_IP_CKSUM_BAD  (1ULL << 4)  /**< IP cksum
> of
> > RX pkt. is not OK. */ -#define PKT_RX_EIP_CKSUM_BAD (0ULL << 0)  /**<
> External IP header checksum error. */
> > -#define PKT_RX_OVERSIZE      (0ULL << 0)  /**< Num of desc of an RX
> pkt oversize. */
> > -#define PKT_RX_HBUF_OVERFLOW (0ULL << 0)  /**< Header buffer
> overflow. */
> > -#define PKT_RX_RECIP_ERR     (0ULL << 0)  /**< Hardware processing
> error. */
> > -#define PKT_RX_MAC_ERR       (0ULL << 0)  /**< MAC error. */
> >  #define PKT_RX_IPV4_HDR      (1ULL << 5)  /**< RX packet with IPv4
> header. */
> >  #define PKT_RX_IPV4_HDR_EXT  (1ULL << 6)  /**< RX packet with
> extended IPv4 header. */
> >  #define PKT_RX_IPV6_HDR      (1ULL << 7)  /**< RX packet with IPv6
> header. */
> > @@ -99,6 +94,10 @@ extern "C" {
> >  #define PKT_RX_TUNNEL_IPV6_HDR (1ULL << 12) /**< RX tunnel packet
> with IPv6 header. */
> >  #define PKT_RX_FDIR_ID       (1ULL << 13) /**< FD id reported if FDIR
> match. */
> >  #define PKT_RX_FDIR_FLX      (1ULL << 14) /**< Flexible bytes reported
> if FDIR match. */
> > +#define PKT_RX_EIP_CKSUM_BAD (1ULL << 15)  /**< External IP header
> checksum error. */
> > +#define PKT_RX_OVERSIZE      (1ULL << 16)  /**< Num of desc of an RX
> pkt oversize. */
> > +#define PKT_RX_HBUF_OVERFLOW (1ULL << 17)  /**< Header buffer
> overflow. */
> > +#define PKT_RX_MAC_ERR       (1ULL << 18)  /**< MAC error. */
> >  /* add new RX flags here */
> 
> I still think there is no point to have several flags to indicate HW error for the
> packet.
> As I suggested before we can collapse 3 of them (OVERSIZE, HBUF_OVERFLOW,
> MAC_ERR) into one.
> As I remember, Oliver even suggested to drop such packets.
> As was said above - if is not a whole packet SW can't do much with it anyway.
> The only thing such bad packets can probably be used for - some sort of
> debugging.
> So we probably can combine both things:
> - in normal operation just drop such packet
> - if PMD_DEBUG_RX is enabled, then write a log record, set RX_HW_ERR and
> deliver a packet to the upper layer.
> 
> >
> >  /* add new TX flags here */
> > @@ -141,13 +140,13 @@ extern "C" {
> >  #define PKT_TX_IP_CKSUM      (1ULL << 54) /**< IP cksum of TX pkt.
> computed by NIC. */
> >  #define PKT_TX_IPV4_CSUM     PKT_TX_IP_CKSUM /**< Alias of
> PKT_TX_IP_CKSUM. */
> >
> > -/** Tell the NIC it's an IPv4 packet. Required for L4 checksum offload or TSO.
> */
> > -#define PKT_TX_IPV4          PKT_RX_IPV4_HDR
> > +/** Tell the NIC it's an IPv4 packet. */
> > +#define PKT_TX_IPV4          (1ULL << 55) /**< TX packet is a IPV4
> packet. */
> >
> > -/** Tell the NIC it's an IPv6 packet. Required for L4 checksum offload or TSO.
> */
> > -#define PKT_TX_IPV6          PKT_RX_IPV6_HDR
> > +/** Tell the NIC it's an IPv6 packet. */
> > +#define PKT_TX_IPV6          (1ULL << 56) /**< TX packet is a IPV6
> packet. */
> >
> > -#define PKT_TX_VLAN_PKT      (1ULL << 55) /**< TX packet is a 802.1q
> VLAN packet. */
> > +#define PKT_TX_VLAN_PKT      (1ULL << 57) /**< TX packet is a VLAN
> packet. */
> 
> I don't think these changes should be part of that patch.
> They violate another patch that Frank sent before.
> 
> Konstantin
> 
> >
> >  /* Use final bit of flags to indicate a control mbuf */
> >  #define CTRL_MBUF_FLAG       (1ULL << 63) /**< Mbuf contains control
> data */
> > --
> > 1.9.3