[dpdk-dev] [PATCH 1/8] bond: use existing enslaved device queues

[Stephen Hemminger]

From: Eric Kinzie <ehkinzie at gmail.com>

This solves issues when an active device is added to a bond.

If a device to be enslaved already has transmit and/or receive queues
allocated, use those and then create any additional queues that are
necessary.

Signed-off-by: Eric Kinzie <ehkinzie at gmail.com>
Signed-off-by: Stephen Hemminger <stephen at networkplumber.org>
---
 drivers/net/bonding/rte_eth_bond_pmd.c | 8 ++++++--
 1 file changed, 6 insertions(+), 2 deletions(-)

diff --git a/drivers/net/bonding/rte_eth_bond_pmd.c b/drivers/net/bonding/rte_eth_bond_pmd.c
index aa985f5..127b976 100644
--- a/drivers/net/bonding/rte_eth_bond_pmd.c
+++ b/drivers/net/bonding/rte_eth_bond_pmd.c
@@ -1340,7 +1340,9 @@ slave_configure(struct rte_eth_dev *bonded_eth_dev,
 	}
 
 	/* Setup Rx Queues */
-	for (q_id = 0; q_id < bonded_eth_dev->data->nb_rx_queues; q_id++) {
+	/* Use existing queues, if any */
+	for (q_id = slave_eth_dev->data->nb_rx_queues;
+	     q_id < bonded_eth_dev->data->nb_rx_queues; q_id++) {
 		bd_rx_q = (struct bond_rx_queue *)bonded_eth_dev->data->rx_queues[q_id];
 
 		errval = rte_eth_rx_queue_setup(slave_eth_dev->data->port_id, q_id,
@@ -1356,7 +1358,9 @@ slave_configure(struct rte_eth_dev *bonded_eth_dev,
 	}
 
 	/* Setup Tx Queues */
-	for (q_id = 0; q_id < bonded_eth_dev->data->nb_tx_queues; q_id++) {
+	/* Use existing queues, if any */
+	for (q_id = slave_eth_dev->data->nb_tx_queues;
+	     q_id < bonded_eth_dev->data->nb_tx_queues; q_id++) {
 		bd_tx_q = (struct bond_tx_queue *)bonded_eth_dev->data->tx_queues[q_id];
 
 		errval = rte_eth_tx_queue_setup(slave_eth_dev->data->port_id, q_id,
-- 
2.1.4