[dpdk-dev] [PATCH v4 2/2] ethdev: add sanity checks to functions
Bruce Richardson
bruce.richardson at intel.com
Tue Nov 17 13:21:07 CET 2015
The functions rte_eth_rx_queue_count and rte_eth_descriptor_done are
supported by very few PMDs. Therefore, it is best to check for support
for the functions in the ethdev library, so as to avoid run-time crashes
at run-time if the application goes to use those APIs. Similarly, the
port parameter should also be checked for validity.
Signed-off-by: Bruce Richardson <bruce.richardson at intel.com>
---
lib/librte_ether/rte_ethdev.h | 15 +++++++--------
1 file changed, 7 insertions(+), 8 deletions(-)
diff --git a/lib/librte_ether/rte_ethdev.h b/lib/librte_ether/rte_ethdev.h
index a00cd46..028be59 100644
--- a/lib/librte_ether/rte_ethdev.h
+++ b/lib/librte_ether/rte_ethdev.h
@@ -2533,16 +2533,16 @@ rte_eth_rx_burst(uint8_t port_id, uint16_t queue_id,
* @param queue_id
* The queue id on the specific port.
* @return
- * The number of used descriptors in the specific queue.
+ * The number of used descriptors in the specific queue, or:
+ * (-EINVAL) if *port_id* is invalid
+ * (-ENOTSUP) if the device does not support this function
*/
-static inline uint32_t
+static inline int
rte_eth_rx_queue_count(uint8_t port_id, uint16_t queue_id)
{
struct rte_eth_dev *dev = &rte_eth_devices[port_id];
-#ifdef RTE_LIBRTE_ETHDEV_DEBUG
- RTE_ETH_VALID_PORTID_OR_ERR_RET(port_id, 0);
- RTE_FUNC_PTR_OR_ERR_RET(*dev->dev_ops->rx_queue_count, 0);
-#endif
+ RTE_ETH_VALID_PORTID_OR_ERR_RET(port_id, -EINVAL);
+ RTE_FUNC_PTR_OR_ERR_RET(*dev->dev_ops->rx_queue_count, -ENOTSUP);
return (*dev->dev_ops->rx_queue_count)(dev, queue_id);
}
@@ -2559,15 +2559,14 @@ rte_eth_rx_queue_count(uint8_t port_id, uint16_t queue_id)
* - (1) if the specific DD bit is set.
* - (0) if the specific DD bit is not set.
* - (-ENODEV) if *port_id* invalid.
+ * - (-ENOTSUP) if the device does not support this function
*/
static inline int
rte_eth_rx_descriptor_done(uint8_t port_id, uint16_t queue_id, uint16_t offset)
{
struct rte_eth_dev *dev = &rte_eth_devices[port_id];
-#ifdef RTE_LIBRTE_ETHDEV_DEBUG
RTE_ETH_VALID_PORTID_OR_ERR_RET(port_id, -ENODEV);
RTE_FUNC_PTR_OR_ERR_RET(*dev->dev_ops->rx_descriptor_done, -ENOTSUP);
-#endif
return (*dev->dev_ops->rx_descriptor_done)( \
dev->data->rx_queues[queue_id], offset);
}
--
2.5.0
More information about the dev
mailing list