[dpdk-dev] [PATCH] Fix VMware emulated e1000 doesn't support INTX_DISABLE flag

Stephen Hemminger stephen at networkplumber.org
Sun Sep 27 23:41:57 CEST 2015


On Sun, 27 Sep 2015 12:51:06 +0400
"Kirill A. Korinsky" <kirill at korins.ky> wrote:

> When you try to run any DPDK-app in VMWare with e1000/82545EM NIC
> you have a lot of lines like:
> 
>   EAL: Error reading from file descriptor 9: Input/output error
> 
> The reason of this error is bad INTX emulation in VMWare
> and pci_intx_mask_supported return false every time.
> ---
>  lib/librte_eal/linuxapp/igb_uio/igb_uio.c | 4 +++-
>  1 file changed, 3 insertions(+), 1 deletion(-)
> 
> diff --git a/lib/librte_eal/linuxapp/igb_uio/igb_uio.c b/lib/librte_eal/linuxapp/igb_uio/igb_uio.c
> index 865a276..c85f7e5 100644
> --- a/lib/librte_eal/linuxapp/igb_uio/igb_uio.c
> +++ b/lib/librte_eal/linuxapp/igb_uio/igb_uio.c
> @@ -36,6 +36,7 @@
>  #ifdef CONFIG_XEN_DOM0
>  #include <xen/xen.h>
>  #endif
> +#include <asm/hypervisor.h>
>  #include <rte_pci_dev_features.h>
>  
>  #include "compat.h"
> @@ -508,7 +509,8 @@ igbuio_pci_probe(struct pci_dev *dev, const struct pci_device_id *id)
>  		}
>  		/* fall back to INTX */
>  	case RTE_INTR_MODE_LEGACY:
> -		if (pci_intx_mask_supported(dev)) {
> +		/*  VMware emulated e1000 doesn't support INTX_DISABLE flag */
> +		if (pci_intx_mask_supported(dev) || x86_hyper == &x86_hyper_vmware) {
>  			dev_dbg(&dev->dev, "using INTX");
>  			udev->info.irq_flags = IRQF_SHARED;
>  			udev->info.irq = dev->irq;

I don't think driver should be expecting INTx to work on VMware.
If kernel test fails, it means masking is broken (in VMware).


It is better for driver (E1000 PMD) to report that Link state interrupt does
not work (if IRQ setup fails). Then application can test if LSC irq works
and not enable it.


More information about the dev mailing list