[dpdk-dev] Pktgen rate issue
Iñaki Murillo
inaki.murilloa at ehu.eus
Thu Apr 21 16:22:12 CEST 2016
Hello Keith,
I have done a patch to the pktgen, but I not sure how to submit it. I
would be very grateful if you give me some advice on how to contribute.
Thank you,
Iñaki Murillo
El 12/04/16 a las 14:55, Wiles, Keith escribió:
>> Hello
>>
>> I have been using pktgen for a while and I released that there is no
>> possibility to set a rate between two whole numbers.
>>
>> I looked up the source code and I found out that the rate is stored in
>> a uint8_t. So, I made a quick-and-dirty change just to check if it is
>> possible to get a speed between two hole numbers. It seemed to work
>> properly.
>>
>> Is there a reason to use an uint8_t instead of a float, for example?
> The uint8_t was easier then using floats :-)
>
> If you have a patch for this change please send it along and I will look at adding the support.
>
>> Thank you,
>>
>> Iñaki Murillo
>>
>
> Regards,
> Keith
>
>
>
>
More information about the dev
mailing list