[dpdk-dev] [PATCH v3] i40e: fix vlan filtering

[Bruce Richardson]

On Fri, Feb 05, 2016 at 12:20:15AM +0000, Zhang, Helin wrote:
> 
> 
> > -----Original Message-----
> > From: Julien Meunier [mailto:julien.meunier at 6wind.com]
> > Sent: Thursday, February 4, 2016 7:02 PM
> > To: Zhang, Helin <helin.zhang at intel.com>
> > Cc: dev at dpdk.org
> > Subject: [PATCH v3] i40e: fix vlan filtering
> > 
> > VLAN filtering was always performed, even if hw_vlan_filter was disabled.
> > During device initialization, default filter RTE_MACVLAN_PERFECT_MATCH
> > was applied. In this situation, all incoming VLAN frames were dropped by the
> > card (increase of the register RUPP - Rx Unsupported Protocol).
> > 
> > In order to restore default behavior, if HW VLAN filtering is activated, set a
> > filter to match MAC and VLAN. If not, set a filter to only match MAC.
> > 
> > Signed-off-by: Julien Meunier <julien.meunier at 6wind.com>
> Acked-by: Helin Zhang <helin.zhang at intel.com>
> 
Applied to dpdk-next-net/rel_16_04

Thanks,
/Bruce