[dpdk-dev] [PATCH V2] doc: fix vhost setup in tep-termination app guide

[Kavanagh, Mark B]

Please disregard - correct version of patch to follow.

Cheers,
Mark

>-----Original Message-----
>From: dev [mailto:dev-bounces at dpdk.org] On Behalf Of Mark Kavanagh
>Sent: Thursday, July 21, 2016 2:04 PM
>To: dev at dpdk.org
>Subject: [dpdk-dev] [PATCH V2] doc: fix vhost setup in tep-termination app guide
>
>- Fix vhost setup flags
>- Add minor edits to improve readability and consistency
>
>---
>
>v2: - revert file mode changes made erroneously in v1
>
>Signed-off-by: Mark Kavanagh <mark.b.kavanagh at intel.com>
>---
> doc/guides/sample_app_ug/tep_termination.rst | 8 ++++----
> 1 file changed, 4 insertions(+), 4 deletions(-)
> mode change 100644 => 100755 doc/guides/sample_app_ug/tep_termination.rst
>
>diff --git a/doc/guides/sample_app_ug/tep_termination.rst
>b/doc/guides/sample_app_ug/tep_termination.rst
>old mode 100644
>new mode 100755
>index 2d86a03..c3d1e97
>--- a/doc/guides/sample_app_ug/tep_termination.rst
>+++ b/doc/guides/sample_app_ug/tep_termination.rst
>@@ -59,8 +59,8 @@ This allows network isolation, QOS, etc to be provided on a per client
>basis.
> In a typical setup, the network overlay tunnel is terminated at the Virtual/Tunnel End Point
>(VEP/TEP).
> The TEP is normally located at the physical host level ideally in the software switch.
> Due to processing constraints and the inevitable bottleneck that the switch
>-becomes the ability to offload overlay support features becomes an important requirement.
>-Intel® XL710 10/40 G Ethernet network card provides hardware filtering
>+becomes, the ability to offload overlay support features becomes an important requirement.
>+Intel® XL710 10/40 Gigabit Ethernet network card provides hardware filtering
> and offload capabilities to support overlay networks implementations such as MAC in UDP and
>MAC in GRE.
>
> Sample Code Overview
>@@ -131,14 +131,14 @@ Compiling the Sample Code
>
>     .. code-block:: console
>
>-        CONFIG_RTE_LIBRTE_VHOST=n
>+        CONFIG_RTE_LIBRTE_VHOST=y
>
>     vhost user is turned on by default in the configure file config/common_linuxapp.
>     To enable vhost cuse, disable vhost user.
>
>     .. code-block:: console
>
>-        CONFIG_RTE_LIBRTE_VHOST_USER=y
>+        CONFIG_RTE_LIBRTE_VHOST_USER=n
>
>      After vhost is enabled and the implementation is selected, build the vhost library.
>
>--
>1.9.3