[dpdk-dev] [PATCH] qat: fix for VFs not getting recognized

[Jerin Jacob]

On Fri, Jun 17, 2016 at 10:18:30AM +0200, Thomas Monjalon wrote:
> 2016-06-16 16:25, Jain, Deepak K:
> > From: Thomas Monjalon [mailto:thomas.monjalon at 6wind.com]
> > > 2016-06-16 16:29, Jain, Deepak K:
> > > > Due to addition of CLASS_ID in EAL, class_id is amended into the code.
> > > 
> > > Why the VF is not recognized?
> > > The class id should not be mandatory.
> > 
> > Without the change proposed, QuickAssist Devices were not visible and hence tests were not running.
> > Seems like changes in EAL especially where class_id is added affected the QuickAssist tests.
> > With this change, QuickAssist devices are visible during tests and tests working fine.
> 
> Which tests?
> Have you investigated why?

Thunderx nicvf also got the same problem when I rebased to
dpdk-next-net/rel_16_07.

The root cause for this issue is that, PCI CLASS_ID EAL add
changeset(701c8d80c820461e8255dfb7387a09f0e54399f0)
has taken care only the pci devices where id table is created
with RTE_PCI_DEVICE

For other devices, class_id comes as 0 instread of RTE_CLASS_ANY_ID and
probe failes. To fix it,

one option is to add RTE_CLASS_ANY_ID for the devices where pci id table is not
created with RTE_PCI_DEVICE

or

somewhere in common-code in the initaization set if class_id = 0 then make it as
RTE_CLASS_ANY_ID(Thats would be a hack).

Seems like first option is correct-way to fix the problem? Any thoughts?

looks like following devices does not exhibit this issue

[dpdk-thunderx] $ grep -r "RTE_PCI_DEVICE" drivers/
drivers/net/szedata2/rte_eth_szedata2.c:
drivers/net/bnx2x/bnx2x_ethdev.c
drivers/net/vmxnet3/vmxnet3_ethdev.c
drivers/net/enic/enic_ethdev.c
drivers/net/e1000/em_ethdev.c
drivers/net/ena/ena_ethdev.c
drivers/net/qede/qede_ethdev.c
drivers/net/ixgbe/ixgbe_ethdev.c:#define RTE_PCI_DEV_ID_DECL_IXGBE(vend,
drivers/net/virtio/virtio_ethdev.c:#define
drivers/net/i40e/i40e_ethdev.c:vend,

Jerin