[dpdk-dev] [PATCH] librte_ether: use RTE_ETH_VALID_PORTID_OR_ERR_RET to check port_id
Mauricio Vásquez
mauricio.vasquezbernal at studenti.polito.it
Tue May 17 22:02:14 CEST 2016
Hello Thomas,
On Fri, May 13, 2016 at 6:20 PM, Thomas Monjalon <thomas.monjalon at 6wind.com>
wrote:
> 2016-04-29 17:23, Mauricio Vasquez B:
> > The RTE_ETH_VALID_PORTID_OR_ERR_RET macro is used in some places
> > to check if a port id is valid or not. This commit makes use of it in
> > some new parts of the code.
>
> There are other occurences:
> rte_eth_dev_socket_id
>
I missed it.
> rte_eth_add_rx_callback
> rte_eth_add_tx_callback
> rte_eth_remove_rx_callback
> rte_eth_remove_tx_callback
>
The macro can not be used on those ones because they set the rte_errno
variable before returning.
> I think it could be done also in examples/ethtool/lib.
>
I'll send v2 including that one.
Mauricio V,
More information about the dev
mailing list