[dpdk-dev] [PATCH v3 0/6] get status of Rx and Tx descriptors

[Ferruh Yigit]

On 3/30/2017 2:30 PM, Thomas Monjalon wrote:
> 2017-03-29 10:36, Olivier Matz:
>> This patchset introduces a new ethdev API:
>> - rte_eth_rx_descriptor_status()
>> - rte_eth_tx_descriptor_status()
>>
>> The Rx API is aims to replace rte_eth_rx_descriptor_done() which
>> does almost the same, but does not differentiate the case of a
>> descriptor used by the driver (not returned to the hw).
>>
>> The usage of these functions can be:
>> - on Rx, anticipate that the cpu is not fast enough to process
>>   all incoming packets, and take dispositions to solve the
>>   problem (add more cpus, drop specific packets, ...)
>> - on Tx, detect that the link is overloaded, and take dispositions
>>   to solve the problem (notify flow control, drop specific
>>   packets)
>>
>> The patchset updates ixgbe, i40e, e1000, mlx5.
>> The other drivers that implement the descriptor_done() API are
>> fm10k, sfc, virtio. They are not updated.

Reminder for following PMDs:
- fm10k
- sfc
- virtio

There are two new eth_dev_ops:
rx_descriptor_status
tx_descriptor_status

"rx_descriptor_status" replaces "rx_descriptor_done"

It is suggested to switch to new one, and implement tx_descriptor_status

Thanks,
ferruh

>> If the new API is accepted, the descriptor_done() can be deprecated,
>> and examples/l3fwd-power will be updated to.
> 
> Applied, thanks
> 
> Next steps:
> - implement it in other drivers
> - deprecate descriptor_done API
> 
> Ferruh, please, could you check with drivers maintainers?
> Thanks
>