[dpdk-dev] [PATCH v2] net/e1000: correct VLAN tag byte order for i35x LB packets

[Roger B. Melton]

On 10/20/17 3:04 PM, Ferruh Yigit wrote:
> On 10/12/2017 10:24 AM, Roger B Melton wrote:
>> When copying VLAN tags from the RX descriptor to the vlan_tci field
>> in the mbuf header,  igb_rxtx.c:eth_igb_recv_pkts() and
>> eth_igb_recv_scattered_pkts() both assume that the VLAN tag is always
>> little endian.  While i350, i354 and /i350vf VLAN non-loopback
>> packets are stored little endian, VLAN tags in loopback packets for
>> those devices are big endian.
>>
>> For i350, i354 and i350vf VLAN loopback packets, swap the tag when
>> copying from the RX descriptor to the mbuf header.  This will ensure
>> that the mbuf vlan_tci is always little endian.
>>
>> Signed-off-by: Roger B Melton <rmelton at cisco.com>
> <...>
>
>> @@ -946,9 +954,16 @@ eth_igb_recv_pkts(void *rx_queue, struct rte_mbuf **rx_pkts,
>>   
>>   		rxm->hash.rss = rxd.wb.lower.hi_dword.rss;
>>   		hlen_type_rss = rte_le_to_cpu_32(rxd.wb.lower.lo_dword.data);
>> -		/* Only valid if PKT_RX_VLAN_PKT set in pkt_flags */
>> -		rxm->vlan_tci = rte_le_to_cpu_16(rxd.wb.upper.vlan);
>> -
>> +		/*
>> +		 * The vlan_tci field is only valid when PKT_RX_VLAN_PKT is
>> +		 * set in the pkt_flags field and must be in CPU byte order.
>> +		 */
>> +		if ((staterr & rte_cpu_to_le_32(E1000_RXDEXT_STATERR_LB)) &&
>> +			(rxq->flags & IGB_RXQ_FLAG_LB_BSWAP_VLAN)) {
> This is adding more condition checks into Rx path.
> What is the performance cost of this addition?

I have not measured the performance cost, but I can collect data. What 
specifically are you looking for?

To be clear the current implementation incorrect as it does not 
normalize the vlan tag to CPU byte order before copying it into mbuf and 
applications have no visibility to determine if the tag in the mbuf is 
big or little endian.

Do you have any suggestions for an alternative approach to avoid rx 
patch checks?

Thanks,
Roger


>
>> +			rxm->vlan_tci = rte_be_to_cpu_16(rxd.wb.upper.vlan);
>> +		} else {
>> +			rxm->vlan_tci = rte_le_to_cpu_16(rxd.wb.upper.vlan);
>> +		}
>>   		pkt_flags = rx_desc_hlen_type_rss_to_pkt_flags(rxq, hlen_type_rss);
>>   		pkt_flags = pkt_flags | rx_desc_status_to_pkt_flags(staterr);
>>   		pkt_flags = pkt_flags | rx_desc_error_to_pkt_flags(staterr);
> <...>
> .
>