[dpdk-dev] [PATCH] doc: update failsafe feature list

[Matan Azrad]

Hi Ferruh

> -----Original Message-----
> From: Ferruh Yigit [mailto:ferruh.yigit at intel.com]
> Sent: Tuesday, September 19, 2017 12:27 PM
> To: Matan Azrad <matan at mellanox.com>; Gaetan Rivet
> <gaetan.rivet at 6wind.com>
> Cc: dev at dpdk.org
> Subject: Re: [dpdk-dev] [PATCH] doc: update failsafe feature list
> 
> On 9/14/2017 4:32 PM, Matan Azrad wrote:
> > Add supported failsafe features to feature list.
> > Remove stats per queue feature from failsafe feature list since
> > queue_stats_mapping_set dev op has not implemented yet.
> >
> > Signed-off-by: Matan Azrad <matan at mellanox.com>
> > ---
> >  doc/guides/nics/features/failsafe.ini | 15 ++++++++++++++-
> >  1 file changed, 14 insertions(+), 1 deletion(-)
> >
> > diff --git a/doc/guides/nics/features/failsafe.ini
> > b/doc/guides/nics/features/failsafe.ini
> > index a42e344..9f48455 100644
> > --- a/doc/guides/nics/features/failsafe.ini
> > +++ b/doc/guides/nics/features/failsafe.ini
> > @@ -4,20 +4,33 @@
> >  ; Refer to default.ini for the full list of available PMD features.
> >  ;
> >  [Features]
> > +Speed capabilities   = Y
> >  Link status          = Y
> >  Link status event    = Y
> >  MTU update           = Y
> >  Jumbo frame          = Y
> > +Scattered Rx         = Y
> > +LRO                  = Y
> > +TSO                  = Y
> >  Promiscuous mode     = Y
> >  Allmulticast mode    = Y
> >  Unicast MAC filter   = Y
> >  Multicast MAC filter = Y
> >  VLAN filter          = Y
> > +Ethertype filter     = Y
> > +N-tuple filter       = Y
> > +SYN filter           = Y
> > +Tunnel filter        = Y
> > +Flexible filter      = Y
> > +Hash filter          = Y
> > +Flow director        = Y
> >  Flow control         = Y
> >  Flow API             = Y
> > +QinQ offload         = Y
> > +L3 checksum offload  = Y
> > +L4 checksum offload  = Y
> >  Packet type parsing  = Y
> >  Basic stats          = Y
> > -Stats per queue      = Y
> >  ARMv7                = Y
> >  ARMv8                = Y
> >  Power8               = Y
> 
> I am not sure if claiming support for these features is correct.
> Failsafe itself doesn't provide these features, but relies underlying hardware
> which we don't really know what they supports or not in this stage.
> 

Don't you think that almost all failsafe features rely underlying hardware or sub PMDs?

> OK for dropping "Stats per queue"
> 
> >