[dpdk-dev] [PATCH] bus/dpaa: do nothing if bus not present
Stephen Hemminger
stephen at networkplumber.org
Wed Dec 5 23:02:30 CET 2018
The DPAA bus support code put out messages like:
dpaax: read_memory_node(): Unable to glob device-tree memory node: (/proc/device-tree/memory[@0-9]*/reg)(3)
dpaax: PA->VA translation not available;
dpaax: Expect performance impact.
These are unnecessary and likely to confuse the end user.
Fix this by doing nothing if bus is empty.
Fixes: 5a7dbb934d75 ("dpaa: enable dpaax library")
Signed-off-by: Stephen Hemminger <stephen at networkplumber.org>
---
drivers/bus/dpaa/dpaa_bus.c | 7 +++++--
1 file changed, 5 insertions(+), 2 deletions(-)
diff --git a/drivers/bus/dpaa/dpaa_bus.c b/drivers/bus/dpaa/dpaa_bus.c
index 203f60dc18cb..204a50b1eba3 100644
--- a/drivers/bus/dpaa/dpaa_bus.c
+++ b/drivers/bus/dpaa/dpaa_bus.c
@@ -542,6 +542,10 @@ rte_dpaa_bus_probe(void)
unsigned int svr_ver;
int probe_all = rte_dpaa_bus.bus.conf.scan_mode != RTE_BUS_SCAN_WHITELIST;
+ /* If DPAA bus is not present nothing needs to be done */
+ if (TAILQ_EMPTY(&rte_dpaa_bus.device_list))
+ return 0;
+
svr_file = fopen(DPAA_SOC_ID_FILE, "r");
if (svr_file) {
if (fscanf(svr_file, "svr:%x", &svr_ver) > 0)
@@ -586,8 +590,7 @@ rte_dpaa_bus_probe(void)
/* Register DPAA mempool ops only if any DPAA device has
* been detected.
*/
- if (!TAILQ_EMPTY(&rte_dpaa_bus.device_list))
- rte_mbuf_set_platform_mempool_ops(DPAA_MEMPOOL_OPS_NAME);
+ rte_mbuf_set_platform_mempool_ops(DPAA_MEMPOOL_OPS_NAME);
return 0;
}
--
2.19.2
More information about the dev
mailing list