[dpdk-dev] [PATCH v6 2/3] net/failsafe: fix removal scope
Matan Azrad
matan at mellanox.com
Sun Feb 11 18:24:31 CET 2018
Fail-safe PMD uses per sub-device flag called "remove" to indicate the
scope where the sub-device was removed physically and its SW resources
should be released.
This flag is set when fail-safe gets RMV notification about the
physical removal of the sub-device and should be unset when all the
sub-device resources is released.
The previous code wrongly unsets the flag in dev_configure() instead of
where all the SW resources release is completed.
Change the remove flag unsetting to be in the end of SW resources
release.
Fixes: a46f8d5 ("net/failsafe: add fail-safe PMD")
Cc: stable at dpdk.org
Signed-off-by: Matan Azrad <matan at mellanox.com>
---
drivers/net/failsafe/failsafe_ether.c | 1 +
drivers/net/failsafe/failsafe_ops.c | 1 -
2 files changed, 1 insertion(+), 1 deletion(-)
diff --git a/drivers/net/failsafe/failsafe_ether.c b/drivers/net/failsafe/failsafe_ether.c
index 4c6e938..d820faf 100644
--- a/drivers/net/failsafe/failsafe_ether.c
+++ b/drivers/net/failsafe/failsafe_ether.c
@@ -280,6 +280,7 @@
/* the end */
break;
}
+ sdev->remove = 0;
failsafe_hotplug_alarm_install(sdev->fs_dev);
}
diff --git a/drivers/net/failsafe/failsafe_ops.c b/drivers/net/failsafe/failsafe_ops.c
index 7a67e16..f0e48c1 100644
--- a/drivers/net/failsafe/failsafe_ops.c
+++ b/drivers/net/failsafe/failsafe_ops.c
@@ -131,7 +131,6 @@
dev->data->dev_conf.intr_conf.lsc = 0;
}
DEBUG("Configuring sub-device %d", i);
- sdev->remove = 0;
ret = rte_eth_dev_configure(PORT_ID(sdev),
dev->data->nb_rx_queues,
dev->data->nb_tx_queues,
--
1.8.3.1
More information about the dev
mailing list