[dpdk-dev] [PATCH] doc: document the new devargs syntax

Thomas Monjalon thomas at monjalon.net
Wed Jan 24 11:21:44 CET 2018


24/01/2018 10:28, Yuanhan Liu:
> On Wed, Jan 24, 2018 at 09:19:10AM +0100, Thomas Monjalon wrote:
> > 24/01/2018 07:43, Yuanhan Liu:
> > > On Tue, Jan 23, 2018 at 03:29:34PM +0100, Thomas Monjalon wrote:
> > > > 23/01/2018 13:46, Yuanhan Liu:
> > > > > If port not found, then the whole string will be used for dev attachment.
> > > > > It means we are attaching a port with PCI BDF == 04.00.0 AND
> > > > > port == 0 (the 2nd port will not be attached).
> > > > > 
> > > > > 
> > > > > And here is how the devargs would look like if "matching;settings" is
> > > > > being used:
> > > > > 
> > > > >     bus=pci,id=04:00.0/class=eth,port=0;bus=pci,id=04:00.0/class=eth,port=0/driver=mlx4,mlx4_arg_A=val,...
> > > > > 
> > > > > The part before ";" will be used for lookup and the later part will be
> > > > > used for attachment. It should work. It just looks redundant.
> > > > 
> > > > It does not have to be redundant.
> > > > It can be:
> > > > 	bus=pci,id=04:00.0/class=eth,port=0;driver=mlx4,mlx4_arg1=settings1,...
> > > 
> > > I knew you would make such reply :)
> > > Then there is a contradiction. According your suggestion, the "port=0" belongs
> > > to the matching section, but it also has to be used in the settings section.
> > 
> > If port=0 is matched, it is already set, right?
> 
> Yes.
> 
> > Why it needs to be in settings?
> 
> But I was talking the case it's not matched, say it's not probed and here
> we do hotplug.

I don't understand.
Anyway, the port property should be read-only.
Are we talking about the dev_port from the Linux kernel?


More information about the dev mailing list