[dpdk-dev] [PATCH v3 0/2] net/failsafe: support multicast MAC address set
Andrew Rybchenko
arybchenko at solarflare.com
Fri Sep 21 18:33:16 CEST 2018
On 9/21/18 7:21 PM, Stephen Hemminger wrote:
> On Fri, 21 Sep 2018 16:36:19 +0100
> Andrew Rybchenko <arybchenko at solarflare.com> wrote:
>
>> v3:
>> - move apply on sync to fs_eth_dev_conf_apply() to apply to
>> a new subdevice only
>> - use ethdev API to apply to sub-device on sync
>> - remove unnecessary check the same pointer from the method
>> implementation in failsafe
>>
>> v2:
>> - fix setting of zero addresses since rte_realloc() returns NULL
>>
>> Evgeny Im (2):
>> net/failsafe: remove not supported multicast MAC filter
>> net/failsafe: support multicast address list set
>>
>> doc/guides/rel_notes/release_18_11.rst | 1 +
>> drivers/net/failsafe/failsafe.c | 1 +
>> drivers/net/failsafe/failsafe_ether.c | 17 +++++++++
>> drivers/net/failsafe/failsafe_ops.c | 50 +++++++++++++++++++++++++
>> drivers/net/failsafe/failsafe_private.h | 2 +
>> 5 files changed, 71 insertions(+)
>>
> Since TAP has no filtering this doesn't really do much for the slowpath.
Yes, I know that TAP does not support it. Is failsafe so tighly bound to
TAP to block it?
More information about the dev
mailing list