[dpdk-dev] [PATCH v2] examples/ip_fragmentation: support big packets

Noa Ezra noae at mellanox.com
Sun Jan 13 12:37:06 CET 2019


In some vendors the RX and TX configuration must be the same, therefore
the MTU size need to be equal to max_rx_pkt_len.
The MTU is the largest size packet in bytes that can be sent on the
network, therefore before changing this parameter, the NIC could not
receive packets larger than 1500 bytes, which is the default MTU size.
In addition, scatter-gather need to be enabled in order to receive
frames bigger than mbuf size.

Signed-off-by: Noa Ezra <noae at mellanox.com>
---
v2: move set_mtu() to be done after dev_configure().

 examples/ip_fragmentation/main.c | 11 +++++++++++
 1 file changed, 11 insertions(+)

diff --git a/examples/ip_fragmentation/main.c b/examples/ip_fragmentation/main.c
index 17a877d..8d789b4 100644
--- a/examples/ip_fragmentation/main.c
+++ b/examples/ip_fragmentation/main.c
@@ -141,6 +141,7 @@ struct lcore_queue_conf {
 		.max_rx_pkt_len = JUMBO_FRAME_MAX_SIZE,
 		.split_hdr_size = 0,
 		.offloads = (DEV_RX_OFFLOAD_CHECKSUM |
+			     DEV_RX_OFFLOAD_SCATTER |
 			     DEV_RX_OFFLOAD_JUMBO_FRAME),
 	},
 	.txmode = {
@@ -935,6 +936,16 @@ struct rte_lpm6_config lpm6_config = {
 				ret, portid);
 		}
 
+		/* set the mtu to the maximum received packet size */
+		ret = rte_eth_dev_set_mtu(portid,
+			local_port_conf.rxmode.max_rx_pkt_len);
+		if (ret < 0) {
+			printf("\n");
+			rte_exit(EXIT_FAILURE, "Set MTU failed: "
+				"err=%d, port=%d\n",
+			ret, portid);
+		}
+
 		ret = rte_eth_dev_adjust_nb_rx_tx_desc(portid, &nb_rxd,
 					    &nb_txd);
 		if (ret < 0) {
-- 
1.8.3.1



More information about the dev mailing list