[dpdk-dev] [PATCH v4 1/3] rte_ethdev: Add API function to read dev clock

Ferruh Yigit ferruh.yigit at intel.com
Tue Jun 4 15:57:01 CEST 2019


On 5/2/2019 1:11 PM, Tom Barbette wrote:
> Add rte_eth_read_clock to read the raw clock of a device.
> 
> The main use is to get the device clock conversion co-efficients to be
> able to translate the raw clock of the timestamp field of the pkt mbuf
> to a local synced time value.
> 
> This function was missing to allow users to convert the Rx timestamp field
> to real time without the complexity of the rte_timesync* facility. One can
> derivate the clock frequency by calling twice read_clock and then keep a
> common time base.
> 
> Signed-off-by: Tom Barbette <barbette at kth.se>

<...>

> +/**
> + * @warning
> + * @b EXPERIMENTAL: this API may change without prior notice.
> + *
> + * Read the current clock counter of an Ethernet device
> + *
> + * This returns the current raw clock value of an Ethernet device. It is
> + * a raw amount of ticks, with no given time reference.
> + * The value returned here is from the same clock than the one
> + * filling timestamp field of Rx packets when using hardware timestamp
> + * offload. Therefore it can be used to compute a precise conversion of
> + * the device clock to the real time.
> + *
> + * E.g, a simple heuristic to derivate the frequency would be:
> + * uint64_t start, end;
> + * rte_eth_read_clock(port, start);
> + * rte_delay_ms(100);
> + * rte_eth_read_clock(port, end);
> + * double freq = (end - start) * 10;
> + *
> + * Compute a common reference with:
> + * uint64_t base_time_sec = current_time();
> + * uint64_t base_clock;
> + * rte_eth_read_clock(port, base_clock);
> + *
> + * Then, convert the raw mbuf timestamp with:
> + * base_time_sec + (double)(mbuf->timestamp - base_clock) / freq;
> + *
> + * This simple example will not provide a very good accuracy. One must
> + * at least measure multiple times the frequency and do a regression.
> + * To avoid deviation from the system time, the common reference can
> + * be repeated from time to time. The integer division can also be
> + * converted by a multiplication and a shift for better performance.
> + *
> + * @param port_id
> + *   The port identifier of the Ethernet device.
> + * @param time
> + *   Pointer to the uint64_t that holds the raw clock value.
> + *
> + * @return
> + *   - 0: Success.
> + *   - -ENODEV: The port ID is invalid.
> + *   - -ENOTSUP: The function is not supported by the Ethernet driver.
> + */
> +int __rte_experimental
> +rte_eth_read_clock(uint16_t port_id, uint64_t *clock);

This is causing doc build error, since @param should be "clock" instead of "time".
I have fixed this in the next-net repo and force pushed.


More information about the dev mailing list