[dpdk-dev] [PATCH v3 2/2] net/mlx5: fix Rx descriptor status returned value

[Maxime Leroy]

Hi Slava,

On Mon, Nov 16, 2020 at 9:03 PM Slava Ovsiienko <viacheslavo at nvidia.com> wrote:
>
> Hi, Maxime
>
> It seems there are some typos (see below).
> Beside these ones - ACKed.
>
> > -----Original Message-----
> > From: Maxime Leroy <maxime.leroy at 6wind.com>
> > Sent: Monday, November 16, 2020 19:03
> > To: Matan Azrad <matan at nvidia.com>; Shahaf Shuler <shahafs at nvidia.com>;
> > Slava Ovsiienko <viacheslavo at nvidia.com>; Olivier Matz
> > <olivier.matz at 6wind.com>
> > Cc: dev at dpdk.org; Didier Pallard <didier.pallard at 6wind.com>
> > Subject: [PATCH v3 2/2] net/mlx5: fix Rx descriptor status returned value
> >
> > From: Didier Pallard <didier.pallard at 6wind.com>
> >
> > Three bugs in rx_queue_count function:
> > - One entry may contain several segments, so 'used' must be multiplied
> >   by number of segments per entry to properly reflect the queue usage.
> > - The number of cqes is equals to (1U << rxq->elts_n) - 1 in non mqrt
> >   mode. The range returned by rx_queue_count should be the number of
>
> Should it be "bullet number 3" ?

This bullet is for SPRQ mode. The bullet number 3 is for MPRQ mode.
Not sure to understand your point.

>
> >   entries used in queue, so it ranges from 0 to max number of entries
> >   in queue, not this number minus one.
>
> WARNING:TYPO_SPELLING: 'acount' may be misspelled - perhaps 'account'?
> Should it be - "to take into account?"
> Should it be "MPRQ" ?

I will fix it in V4.

Thanks for the review.

>
> > - For MQRT mode, we need to take acount of the number of strd.
> >
> > Fixes: 8788fec1f269 ("net/mlx5: implement descriptor status API")
> > Signed-off-by: Didier Pallard <didier.pallard at 6wind.com>
> > Signed-off-by: Maxime Leroy <maxime.leroy at 6wind.com>
> Acked-by: Viacheslav Ovsiienko <viacheslavo at nvidia.com>
>