[dpdk-dev] [PATCH] net/i40e: issue with ADD VLAN from Guest

[Dey, Souvik]

Hi Zhang,
I have submitted this patch way back in April and I see the patch has been deferred. Is there any particular reason behind that. As I have not received any communication about that was just wondering if there is something wrong that I might have done in the patch submission process to cause this.
Thanks for your help.
--
Regards,
Souvik

-----Original Message-----
From: Dey, Souvik <sodey at rbbn.com>
Sent: Tuesday, April 14, 2020 5:59 PM
To: beilei.xing at intel.com; qi.z.zhang at intel.com
Cc: dev at dpdk.org; Dey, Souvik <sodey at rbbn.com>
Subject: [PATCH] net/i40e: issue with ADD VLAN from Guest

From: "Dey, Souvik" <sodey at rbbn.com>

In case of i40evf pmd, when ADD_VLAN is sent down the linux i40e driver, along with add the vlan the kernel driver also enables the vlan stripping by default.
This might have issues if the app configured DEV_RX_OFFLOAD_VLAN_STRIP as off at the port configuration. The app after adding the VLAN will expect the VLAN to be coming in the received packets but, due to VLAN_STRIP enabled at the PF, it will get stripped.
This behavior of the Linux driver causes confussion with the DPDK app using i40e_pmd. So it is better to check the state of the DEV_RX_OFFLOAD_VLAN_STRIP flag in the dev_conf and disable the vlan strip after sending add_vlan if app configured the VLAN_STRIP as disabled.


Signed-off-by: Souvik Dey <sodey at rbbn.com>
---
 drivers/net/i40e/i40e_ethdev_vf.c | 16 +++++++++++++++-
 1 file changed, 15 insertions(+), 1 deletion(-)

diff --git a/drivers/net/i40e/i40e_ethdev_vf.c b/drivers/net/i40e/i40e_ethdev_vf.c
index 244397e..b8b6c57 100644
--- a/drivers/net/i40e/i40e_ethdev_vf.c
+++ b/drivers/net/i40e/i40e_ethdev_vf.c
@@ -1044,6 +1044,7 @@ i40evf_add_vlan(struct rte_eth_dev *dev, uint16_t vlanid)  {
 struct i40e_vf *vf = I40EVF_DEV_PRIVATE_TO_VF(dev->data->dev_private);
 struct virtchnl_vlan_filter_list *vlan_list;
+struct rte_eth_conf *dev_conf = &dev->data->dev_conf;
 uint8_t cmd_buffer[sizeof(struct virtchnl_vlan_filter_list) +
 sizeof(uint16_t)];
 int err;
@@ -1060,8 +1061,21 @@ i40evf_add_vlan(struct rte_eth_dev *dev, uint16_t vlanid)
 args.out_buffer = vf->aq_resp;
 args.out_size = I40E_AQ_BUF_SZ;
 err = i40evf_execute_vf_cmd(dev, &args);
-if (err)
+if (err) {
 PMD_DRV_LOG(ERR, "fail to execute command OP_ADD_VLAN");
+return ret;
+}
+/*
+ * In linux kernel driver on receiving ADD_VLAN it enables
+ * VLAN_STRIP by default. So disable it if app confifured
+ * it that way.
+ */
+if (!(dev_conf->rxmode.offloads & DEV_RX_OFFLOAD_VLAN_STRIP)) {
+err = i40evf_disable_vlan_strip(dev);
+if (err)
+PMD_DRV_LOG(ERR, "fail to execute command disable_vlan_strip "
+"as a part of OP_ADD_VLAN");
+}

 return err;
 }
--
2.9.3.windows.1