[dpdk-dev] [EXT] [PATCH v4] cryptodev: support multiple cipher data-units

[Akhil Goyal]

> 
> 14/04/2021 20:37, Akhil Goyal:
> > Hi Thomas,
> >
> > > +	RTE_STD_C11
> > > +	union { /* temporary anonymous union for ABI compatibility */
> > > +
> > >  	struct {
> > >  		const uint8_t *data;	/**< pointer to key data */
> > >  		uint16_t length;	/**< key length in bytes */
> > > @@ -222,6 +225,27 @@ struct rte_crypto_cipher_xform {
> > >  	 *  - Each key can be either 128 bits (16 bytes) or 256 bits (32 bytes).
> > >  	 *  - Both keys must have the same size.
> > >  	 **/
> > > +
> > > +	RTE_STD_C11
> > > +	struct { /* temporary anonymous struct for ABI compatibility */
> > > +		const uint8_t *_key_data; /* reserved for key.data union */
> > > +		uint16_t _key_length;     /* reserved for key.length union */
> > > +		/* next field can fill the padding hole */
> > > +
> > > +	uint16_t dataunit_len;
> > > +	/**< When RTE_CRYPTODEV_FF_CIPHER_MULTIPLE_DATA_UNITS is
> > > enabled,
> > > +	 * this is the data-unit length of the algorithm,
> > > +	 * otherwise or when the value is 0, use the operation length.
> > > +	 * The value should be in the range defined by the dataunit_set field
> > > +	 * in the cipher capability.
> > > +	 *
> > > +	 * - For AES-XTS it is the size of data-unit, from IEEE Std 1619-2007.
> > > +	 * For-each data-unit in the operation, the tweak (IV) value is
> > > +	 * assigned consecutively starting from the operation assigned IV.
> > > +	 */
> > > +
> > > +	}; }; /* temporary struct nested in union for ABI compatibility */
> > > +
> > Can we add a deprecation notice also in this patch to remove these
> temporary
> > Struct and union, so that we remember to remove them in 21.11
> 
> I thought about it, but a deprecation notice may involve
> new design considerations and requires 3 approvals.
> I think it is better to send it separately.
In that case you can send it as a separate patch now only.
Just wanted to make sure that it is not forgotten.

> 
> > > @@ -127,6 +135,11 @@ struct rte_cryptodev_symmetric_capability {
> > >  			/**< cipher key size range */
> > >  			struct rte_crypto_param_range iv_size;
> > >  			/**< Initialisation vector data size range */
> > > +			uint32_t dataunit_set;
> > > +			/**<
> > > +			 * A bitmap for a set of the supported data-unit
> > > lengths.
> >
> > Add reference to the newly created macros here
> >
> > > +			 * 0 for any length defined in the algorithm standard.
> > > +			 */
> 
> Yes, I've seen this miss after sending.
> I'll reword like this:
>   * Supported data-unit lengths:
>   * RTE_CRYPTO_CIPHER_DATA_UNIT_LEN_* bits
>   * or 0 for lengths defined in the algorithm standard.

OK