[PATCH] net/bnxt: fix autoneg on PAM4 links

[Somnath Kotur]

If autonegotiation was enabled, driver was not passing the
'auto_pam4_link_speeds' obtained during init and stored in bp->link_info
to bnxt_hwrm_port_phy_cfg(). This would result in an incorrect setting
being passed to the HW during PHY configuration. This in turn, would
result in invalid settings being retrieved and configured in subsequent
application loads resulting in launch failures.

Fixes: c23f9ded0391 ("net/bnxt: support 200G PAM4 link")

Reported-by: Charlie Brtee <cfb at hpe.com>
Reviewed-by: Ajit Khaparde <ajit.khaparde at broadcom.com>
Signed-off-by: Somnath Kotur <somnath.kotur at broadcom.com>
---
 drivers/net/bnxt/bnxt_hwrm.c | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/drivers/net/bnxt/bnxt_hwrm.c b/drivers/net/bnxt/bnxt_hwrm.c
index 67ed807dad..df75047e2d 100644
--- a/drivers/net/bnxt/bnxt_hwrm.c
+++ b/drivers/net/bnxt/bnxt_hwrm.c
@@ -3247,6 +3247,8 @@ int bnxt_set_hwrm_link_config(struct bnxt *bp, bool link_up)
 		link_req.auto_link_speed_mask =
 			bnxt_parse_eth_link_speed_mask(bp,
 						       dev_conf->link_speeds);
+		link_req.auto_pam4_link_speeds =
+			bp->link_info->auto_pam4_link_speeds;
 	} else {
 		if (bp->link_info->phy_type ==
 		    HWRM_PORT_PHY_QCFG_OUTPUT_PHY_TYPE_BASET ||
-- 
2.28.0.497.g54e85e7