[PATCH v1 1/3] fix PMD wording typo

[Walsh, Conor]

Hi Sean,

A few minor nits, TBH not sure if they should be changed in this patch as this patch is just removing "driver" and correcting capitalisation of PMD.

<snip>


> diff --git a/drivers/net/hns3/hns3_ethdev.h
> b/drivers/net/hns3/hns3_ethdev.h
> index 6d30125dcc..488fe8dbbc 100644
> --- a/drivers/net/hns3/hns3_ethdev.h
> +++ b/drivers/net/hns3/hns3_ethdev.h
> @@ -465,7 +465,7 @@ struct hns3_queue_intr {
>  	 *     enable Rx interrupt.
>  	 *
>  	 *  - HNS3_INTR_MAPPING_VEC_ALL
> -	 *     PMD driver can map/unmmap all interrupt vectors with queues
> When
> +	 *     PMD can map/unmmap all interrupt vectors with queues When


"When" shouldn't be capitalised here.


>  	 *     Rx interrupt in enabled.


in => is


>  	 */
>  	uint8_t mapping_mode;


<snip>


> diff --git a/drivers/net/hns3/hns3_ethdev_vf.c
> b/drivers/net/hns3/hns3_ethdev_vf.c
> index d8a99693e0..7d6e251bbe 100644
> --- a/drivers/net/hns3/hns3_ethdev_vf.c
> +++ b/drivers/net/hns3/hns3_ethdev_vf.c
> @@ -232,7 +232,7 @@ hns3vf_set_default_mac_addr(struct rte_eth_dev
> *dev,
>  				HNS3_TWO_ETHER_ADDR_LEN, true, NULL,
> 0);
>  	if (ret) {
>  		/*
> -		 * The hns3 VF PMD driver depends on the hns3 PF kernel
> ethdev
> +		 * The hns3 VF PMD depends on the hns3 PF kernel ethdev
>  		 * driver. When user has configured a MAC address for VF
> device
>  		 * by "ip link set ..." command based on the PF device, the
> hns3
>  		 * PF kernel ethdev driver does not allow VF driver to request
> @@ -312,9 +312,9 @@ hns3vf_set_promisc_mode(struct hns3_hw *hw,
> bool en_bc_pmc,
>  	req = (struct hns3_mbx_vf_to_pf_cmd *)desc.data;
> 
>  	/*
> -	 * The hns3 VF PMD driver depends on the hns3 PF kernel ethdev
> driver,
> +	 * The hns3 VF PMD depends on the hns3 PF kernel ethdev driver,
>  	 * so there are some features for promiscuous/allmulticast mode in
> hns3
> -	 * VF PMD driver as below:
> +	 * VF PMD as below:
>  	 * 1. The promiscuous/allmulticast mode can be configured
> successfully
>  	 *    only based on the trusted VF device. If based on the non trusted
>  	 *    VF device, configuring promiscuous/allmulticast mode will fail.
> @@ -322,14 +322,14 @@ hns3vf_set_promisc_mode(struct hns3_hw *hw,
> bool en_bc_pmc,
>  	 *    kernel ethdev driver on the host by the following command:
>  	 *      "ip link set <eth num> vf <vf id> turst on"
>  	 * 2. After the promiscuous mode is configured successfully, hns3 VF
> PMD
> -	 *    driver can receive the ingress and outgoing traffic. In the words,
> +	 *    can receive the ingress and outgoing traffic. In the words,


"In the words" doesn't make any sense here even, "In other words," doesn't really work either.


>  	 *    all the ingress packets, all the packets sent from the PF and
>  	 *    other VFs on the same physical port.
>  	 * 3. Note: Because of the hardware constraints, By default vlan filter
>  	 *    is enabled and couldn't be turned off based on VF device, so vlan
>  	 *    filter is still effective even in promiscuous mode. If upper
>  	 *    applications don't call rte_eth_dev_vlan_filter API function to
> -	 *    set vlan based on VF device, hns3 VF PMD driver will can't receive
> +	 *    set vlan based on VF device, hns3 VF PMD will can't receive
>  	 *    the packets with vlan tag in promiscuoue mode.
>  	 */
>  	hns3_cmd_setup_basic_desc(&desc, HNS3_OPC_MBX_VF_TO_PF,
> false);


With or without these changes:
Reviewed-by: Conor Walsh <conor.walsh at intel.com>

Thanks,
Conor.