[PATCH v1 1/1] doc: update to Intel vRAN Boost PMD

[Nicolas Chautru]

Cosmetic change to refer explictly to the full name of the PMD
Intel vRAN Boost v1.
VRB1 acronym is only used as a prefix within the code.

Signed-off-by: Nicolas Chautru <nicolas.chautru at intel.com>
---
 doc/guides/bbdevs/vrb1.rst | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/doc/guides/bbdevs/vrb1.rst b/doc/guides/bbdevs/vrb1.rst
index f5a9dff804..9c48d30964 100644
--- a/doc/guides/bbdevs/vrb1.rst
+++ b/doc/guides/bbdevs/vrb1.rst
@@ -104,7 +104,7 @@ Initialization
 --------------
 
 When the device first powers up, its PCI Physical Functions (PF)
-can be listed through these commands for VRB1:
+can be listed through these commands for Intel vRAN Boost v1:
 
 .. code-block:: console
 
@@ -123,7 +123,7 @@ Install the DPDK igb_uio driver, bind it with the PF PCI device ID and use
 ``lspci`` to confirm the PF device is under use by ``igb_uio`` DPDK UIO driver.
 
 The igb_uio driver may be bound to the PF PCI device using one of two methods
-for VRB1:
+for Intel vRAN Boost v1:
 
 #. PCI functions (physical or virtual, depending on the use case) can be bound
 to the UIO driver by repeating this command for every function.
@@ -252,7 +252,7 @@ from the VF and not only limited to the PF as captured above.
 
 See for more details: https://github.com/intel/pf-bb-config
 
-Specifically for the bbdev VRB1 PMD, the command below can be used
+Specifically for the bbdev Intel vRAN Boost v1 PMD, the command below can be used
 (note that ACC200 was used previously to refer to VRB1):
 
 .. code-block:: console
-- 
2.34.1