[PATCH v1 1/1] doc: update to Intel vRAN Boost PMD

[Maxime Coquelin]

On 2/27/23 10:04, Maxime Coquelin wrote:
> 
> 
> On 2/24/23 19:20, Nicolas Chautru wrote:
>> Cosmetic change to refer explictly to the full name of the PMD

Fixed explictly -> explicitly

>> Intel vRAN Boost v1.
>> VRB1 acronym is only used as a prefix within the code.
>>
>> Signed-off-by: Nicolas Chautru <nicolas.chautru at intel.com>
>> ---
>>   doc/guides/bbdevs/vrb1.rst | 6 +++---
>>   1 file changed, 3 insertions(+), 3 deletions(-)
>>
>> diff --git a/doc/guides/bbdevs/vrb1.rst b/doc/guides/bbdevs/vrb1.rst
>> index f5a9dff804..9c48d30964 100644
>> --- a/doc/guides/bbdevs/vrb1.rst
>> +++ b/doc/guides/bbdevs/vrb1.rst
>> @@ -104,7 +104,7 @@ Initialization
>>   --------------
>>   When the device first powers up, its PCI Physical Functions (PF)
>> -can be listed through these commands for VRB1:
>> +can be listed through these commands for Intel vRAN Boost v1:
>>   .. code-block:: console
>> @@ -123,7 +123,7 @@ Install the DPDK igb_uio driver, bind it with the 
>> PF PCI device ID and use
>>   ``lspci`` to confirm the PF device is under use by ``igb_uio`` DPDK 
>> UIO driver.
>>   The igb_uio driver may be bound to the PF PCI device using one of 
>> two methods
>> -for VRB1:
>> +for Intel vRAN Boost v1:
>>   #. PCI functions (physical or virtual, depending on the use case) 
>> can be bound
>>   to the UIO driver by repeating this command for every function.
>> @@ -252,7 +252,7 @@ from the VF and not only limited to the PF as 
>> captured above.
>>   See for more details: https://github.com/intel/pf-bb-config
>> -Specifically for the bbdev VRB1 PMD, the command below can be used
>> +Specifically for the bbdev Intel vRAN Boost v1 PMD, the command below 
>> can be used
>>   (note that ACC200 was used previously to refer to VRB1):
>>   .. code-block:: console
> 
> Reviewed-by: Maxime Coquelin <maxime.coquelin at redhat.com>
> 
> Thanks,
> Maxime


Applied to dpdk-next-baseband/for-main.

Thanks,
Maxime