[PATCH] net/rte_net: fix inner L2 length for tunneled Ethernet packets

[Andrew Rybchenko]

On 8/1/25 14:28, Khadem Ullah wrote:
> Hi Andrew,
> 
> Thanks for your feedback.
> 
> Please check mbuf packet types and the following test case:
> https://doc.dpdk.org/dts-20.02/test_plans/uni_pkt_test_plan.html#test-case-vxlan-tunnel-packet-type-detect
> sendp([Ether()/IP()/UDP()/Vxlan()/Ether()/IP(frag=5)/Raw('\0'*40)],
> iface=txItf)
> 
> (outer) L2 type: ETHER
> (outer) L3 type: IPV4_EXT_UNKNOWN
> (outer) L4 type: Unknown
> Tunnel type: GRENAT
> Inner L2 type: ETHER
> Inner L3 type: IPV4_EXT_UNKNOWN
> Inner L4 type: L4_FRAG
> 
> 
> union {
>          uint32_t packet_type; /**< L2/L3/L4 and tunnel information. */
>          __extension__
>          struct {
>            uint8_t l2_type:4;   /**< (Outer) L2 type. */
>            uint8_t l3_type:4;   /**< (Outer) L3 type. */
>            uint8_t l4_type:4;   /**< (Outer) L4 type. */
>            uint8_t tun_type:4;  /**< Tunnel type. */
>            union {
>              uint8_t inner_esp_next_proto;
>              /**< ESP next protocol type, valid if
>               * RTE_PTYPE_TUNNEL_ESP tunnel type is set
>               * on both Tx and Rx.
>               */
>              __extension__
>              struct {
>                uint8_t inner_l2_type:4;
>                /**< Inner L2 type. */
>                uint8_t inner_l3_type:4;
>                /**< Inner L3 type. */
>              };
>            };
>            uint8_t inner_l4_type:4; /**< Inner L4 type. */
>          };
>        };
> 
> 
> Based on the above, it seems that inner_l2_len have to the length of Ether.


Why?

> Ther might need to be some correspondent between both fields to potray the same information.
> Or, the inner_l2_type and inner_l2_len are completly different ?

Definition says that it is different.

> 
> Best Regards,
> Khadem