[dpdk-test-report] |FAILURE| pw(88969) net/bnxt: address unused variable warning
sys_stv at intel.com
sys_stv at intel.com
Fri Mar 12 00:40:10 CET 2021
Test-Label: Intel-compilation
Test-Status: FAILURE
http://dpdk.org/patch/88969
_apply issues_
Submitter: Ajit Khaparde <ajit.khaparde at broadcom.com>
Date: 2021-03-11 23:30:05
Reply_mail: 20210311233005.67032-1-ajit.khaparde at broadcom.com
DPDK git baseline:
Repo:dpdk-next-net-brcm, CommitID: 222e4ce24cd0f511f85bae63585005f9d2e5df99
Repo:dpdk, CommitID: 1e28e842e08428ff5716fbe909bf5acd0365aaf6
* Repo: dpdk-next-net-brcm
This will be required in git-pw 2.0
Starting new HTTP connection (1): proxy-shz.intel.com
Starting new HTTP connection (1): proxy-shz.intel.com
error: patch failed: drivers/net/bnxt/bnxt_ethdev.c:3079
error: drivers/net/bnxt/bnxt_ethdev.c: patch does not apply
Applying: net/bnxt: address unused variable warning
Patch failed at 0001 net/bnxt: address unused variable warning
Use 'git am --show-current-patch' to see the failed patch
When you have resolved this problem, run "git am --continue".
If you prefer to skip this patch, run "git am --skip" instead.
To restore the original branch and stop patching, run "git am --abort".
* Repo: dpdk
net/hns3: fix imprecise statistics
Currently, the hns3 statistics may be inaccurate due to the
following two problems:
1. Queue-level statistics are read from the firmware, and only one Rx or
Tx can be read at a time. This results in a large time interval
--
2. The current statistics are read by type. The HW statistics are read
first, and then the software statistics are read. Due to preceding
reasons, HW reading may be time-consuming, which cause a
synchronization problem between SW and HW statistics of the same
queue.
In this patch, queue-level statistics are directly read from the bar
--
This will be required in git-pw 2.0
Starting new HTTP connection (1): proxy-shz.intel.com
Starting new HTTP connection (1): proxy-shz.intel.com
error: patch failed: drivers/net/bnxt/bnxt_ethdev.c:3079
error: drivers/net/bnxt/bnxt_ethdev.c: patch does not apply
Applying: net/bnxt: address unused variable warning
Patch failed at 0001 net/bnxt: address unused variable warning
Use 'git am --show-current-patch' to see the failed patch
When you have resolved this problem, run "git am --continue".
If you prefer to skip this patch, run "git am --skip" instead.
To restore the original branch and stop patching, run "git am --abort".
DPDK STV team
More information about the test-report
mailing list