Initializing and starting port on primary but transmitting on secondary I get port not ready

[Anna Tauzzi]

I initialize a port with the following methods on a primary process:

rte_dev_probe(vf)

rte_eth_dev_configure(port_id, ... );

rte_eth_dev_adjust_nb_rx_tx_desc(port_id, ... );

rte_eth_rx_queue_setup(port_id, .... );

rte_eth_tx_queue_setup(port_id, ... );

rte_eth_dev_start(port_id ... );



Then I use the rte_eth_tx_burst(port_id) in the secondary process but I get
this message:

called tx_pkt_burst for not ready port 0

Is this expected?
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mails.dpdk.org/archives/users/attachments/20220831/80e18d25/attachment-0001.htm>