<div dir="ltr"><p>Hi Guys,</p><p>Using Dpdk verion : 18.11<br></p><p>Could you please help me figure out why  get link status still reports interface as UP even though the link is Down.<br></p><p>Intel card:<br></p><p>06:00.0 Ethernet controller: Intel Corporation Device 15e4 (rev 11) - X553<br>06:00.1 Ethernet controller: Intel Corporation Device 15e4 (rev 11) - X553<br>07:00.0 Ethernet controller: Intel Corporation Device 15e5 (rev 11) - X553<br></p><p>Problem: Even after bringing DOWN the port, get link status still reports interface UP.<br></p><p>My investigation:</p><p>1. in ixgbe/base/ixgbe_type.h  i see these being defined. Not sure why its defined under  this following comment /* Placeholder value, pending official value. */ <br></p><p>#define IXGBE_DEV_ID_X550EM_A_1G_T              0x15E4<br>#define IXGBE_DEV_ID_X550EM_A_1G_T_L            0x15E5</p><p>From this detail i can conclude we have support for above nics.<br></p><p>2. <a href="https://doc.dpdk.org/guides-18.11/nics/ixgbe.html#supported-chipsets-and-nics" target="_blank">https://doc.dpdk.org/guides-18.11/nics/ixgbe.html#supported-chipsets-and-nics</a>     - This link has supported nics and these above nics are not listed under this.</p><p><br></p><p>3. After putting some debug statement in ixgbe driver  the problem seem to be in  base/ixgbe_common.c(ixgbe_check_mac_link_generic() function)<br></p><p>        links_orig = IXGBE_READ_REG(hw, IXGBE_LINKS);<br>       links_reg = IXGBE_READ_REG(hw, IXGBE_LINKS);<br>       if (links_orig != links_reg) {</p><p>4. I suspect on the resister value used to identify the link status is messing up.<br></p><p>Could you please provide your input.<br></p><p>Thank you so much for your time.</p></div>