[dpdk-dev] Relationship between H/W ring and S/W ring

[Gyumin]

Thanks Bruce.

I also agree with that the size of the S/W ring depends on the 
configuration parameters because the size of the S/W ring is 
/sizeof(struct igb_rx_entry) * len/ in the ixgbe_dev_rx_queue_setup 
function. H/W ring is also allocated in the same function by using the 
ring_dma_zone_reserve function, and its size is RX_RING_SZ. I don't 
think the RX_RING_SZ is configurable but it is fixed value. Is there any 
other code configuring the size of H/W ring?

2014-10-30 오후 6:55에 Bruce Richardson 이(가) 쓴 글:
> On Thu, Oct 30, 2014 at 04:32:16PM +0900, Gyumin wrote:
>> Hi
>>
>> I`m reading the ixgbe code especially about H/W ring and S/W ring. Is the
>> relationship between H/W ring and S/W ring one-to-one mapping?
>> As far as I know, H/W ring size is determined in the code(hard coded) while
>> S/W ring size is determined in port configuration time.
>> In the ixgbe_rx_alloc_bufs function, H/W ring header address and packet
>> address indicate the DMA address of S/W ring's mbuf. I understand it means
>> that the relationship between the H/W ring and S/W ring is one-to-one
>> mapping. For example, if the size of H/W ring is greater than the size of
>> S/W ring then some portion of H/W ring is unused. Is it correct?
>>
>> Thanks
> Hi,
>
> Yes, there is a 1:1 mapping between the hardware and software ring entries, and both are sized depending on the configuration parameters passed to the ring setup APIs. As you state, the HW ring contains the DMA addresses of the packet buffers, while the sw_ring contains the pointers to the original mbufs. The two rings are always kept in sync in the code.
>
> /Bruce
>