[dpdk-dev] Issue with non-scattered rx in ixgbe and i40e when mbuf private area size is odd

Zhang, Helin helin.zhang at intel.com
Wed Jul 29 22:24:11 CEST 2015


Hi Martin

Thank you very much for the good catch!

The similar situation in i40e, as explained by Konstantin.
As header split hasn't been supported by DPDK till now. It would be better to put the header address in RX descriptor to 0.
But in the future, during header split enabling. We may need to pay extra attention to that. As at least x710 datasheet said specifically as below.
"The header address should be set by the software to an even number (word aligned address)". We may need to find a way to ensure that during mempool/mbuf allocation.

Regards,
Helin

> -----Original Message-----
> From: Ananyev, Konstantin
> Sent: Wednesday, July 29, 2015 11:12 AM
> To: Martin Weiser; Zhang, Helin; olivier.matz at 6wind.com
> Cc: dev at dpdk.org
> Subject: RE: [dpdk-dev] Issue with non-scattered rx in ixgbe and i40e when mbuf
> private area size is odd
> 
> Hi Martin,
> 
> > -----Original Message-----
> > From: dev [mailto:dev-bounces at dpdk.org] On Behalf Of Martin Weiser
> > Sent: Wednesday, July 29, 2015 4:07 PM
> > To: Zhang, Helin; olivier.matz at 6wind.com
> > Cc: dev at dpdk.org
> > Subject: [dpdk-dev] Issue with non-scattered rx in ixgbe and i40e when
> > mbuf private area size is odd
> >
> > Hi Helin, Hi Olivier,
> >
> > we are seeing an issue with the ixgbe and i40e drivers which we could
> > track down to our setting of the private area size of the mbufs.
> > The issue can be easily reproduced with the l2fwd example application
> > when a small modification is done: just set the priv_size parameter in
> > the call to the rte_pktmbuf_pool_create function to an odd number like
> > 1. In our tests this causes every call to rte_eth_rx_burst to return
> > 32 (which is the setting of nb_pkts) nonsense mbufs although no
> > packets are received on the interface and the hardware counters do not
> > report any received packets.
> 
> From Niantic datasheet:
> 
> "7.1.6.1 Advanced Receive Descriptors — Read Format Table 7-15 lists the
> advanced receive descriptor programming by the software. The ...
> Packet Buffer Address (64)
> This is the physical address of the packet buffer. The lowest bit is A0 (LSB of the
> address).
> Header Buffer Address (64)
> The physical address of the header buffer with the lowest bit being Descriptor
> Done (DD).
> When a packet spans in multiple descriptors, the header buffer address is used
> only on the first descriptor. During the programming phase, software must set
> the DD bit to zero (see the description of the DD bit in this section). This means
> that header buffer addresses are always word aligned."
> 
> Right now, in ixgbe PMD we always setup  Packet Buffer Address (PBA)and
> Header Buffer Address (HBA) to the same value:
> buf_physaddr + RTE_PKTMBUF_HEADROOM
> So when pirv_size==1, DD bit in RXD is always set to one by SW itself, and then
> SW considers that HW already done with it.
> In other words, right now for ixgbe you can't use RX buffer that is not aligned on
> word boundary.
> 
> So the advice would be, right now - don't set priv_size to the odd value.
> As we don't support split header feature anyway, I think we can fix it just by
> always setting HBA in the RXD to zero.
> Could you try the fix for ixgbe below?
> 
> Same story with FVL, I believe.
> Konstantin
> 
> 
> > Interestingly this does not happen if we force the scattered rx path.
> >
> > I assume the drivers have some expectations regarding the alignment of
> > the buf_addr in the mbuf and setting an odd private are size breaks
> > this alignment in the rte_pktmbuf_init function. If this is the case
> > then one possible fix might be to enforce an alignment on the private area size.
> >
> > Best regards,
> > Martin
> 
> diff --git a/drivers/net/ixgbe/ixgbe_rxtx.c b/drivers/net/ixgbe/ixgbe_rxtx.c
> index a0c8847..94967c5 100644
> --- a/drivers/net/ixgbe/ixgbe_rxtx.c
> +++ b/drivers/net/ixgbe/ixgbe_rxtx.c
> @@ -1183,7 +1183,7 @@ ixgbe_rx_alloc_bufs(struct ixgbe_rx_queue *rxq, bool
> reset_mbuf)
> 
>                 /* populate the descriptors */
>                 dma_addr =
> rte_cpu_to_le_64(RTE_MBUF_DATA_DMA_ADDR_DEFAULT(mb));
> -               rxdp[i].read.hdr_addr = dma_addr;
> +               rxdp[i].read.hdr_addr = 0;
>                 rxdp[i].read.pkt_addr = dma_addr;
>         }
> 
> @@ -1414,7 +1414,7 @@ ixgbe_recv_pkts(void *rx_queue, struct rte_mbuf
> **rx_pkts,
>                 rxe->mbuf = nmb;
>                 dma_addr =
> 
> rte_cpu_to_le_64(RTE_MBUF_DATA_DMA_ADDR_DEFAULT(nmb));
> -               rxdp->read.hdr_addr = dma_addr;
> +               rxdp->read.hdr_addr = 0;
>                 rxdp->read.pkt_addr = dma_addr;
> 
>                 /*
> @@ -1741,7 +1741,7 @@ next_desc:
>                         rxe->mbuf = nmb;
> 
>                         rxm->data_off = RTE_PKTMBUF_HEADROOM;
> -                       rxdp->read.hdr_addr = dma;
> +                       rxdp->read.hdr_addr = 0;
>                         rxdp->read.pkt_addr = dma;
>                 } else
>                         rxe->mbuf = NULL; @@ -3633,7 +3633,7 @@
> ixgbe_alloc_rx_queue_mbufs(struct ixgbe_rx_queue *rxq)
>                 dma_addr =
> 
> rte_cpu_to_le_64(RTE_MBUF_DATA_DMA_ADDR_DEFAULT(mbuf));
>                 rxd = &rxq->rx_ring[i];
> -               rxd->read.hdr_addr = dma_addr;
> +               rxd->read.hdr_addr = 0;
>                 rxd->read.pkt_addr = dma_addr;
>                 rxe[i].mbuf = mbuf;
>         }
> diff --git a/drivers/net/ixgbe/ixgbe_rxtx_vec.c
> b/drivers/net/ixgbe/ixgbe_rxtx_vec.c
> index 6c1647e..16a9c64 100644
> --- a/drivers/net/ixgbe/ixgbe_rxtx_vec.c
> +++ b/drivers/net/ixgbe/ixgbe_rxtx_vec.c
> @@ -56,6 +56,8 @@ ixgbe_rxq_rearm(struct ixgbe_rx_queue *rxq)
>                         RTE_PKTMBUF_HEADROOM);
>         __m128i dma_addr0, dma_addr1;
> 
> +       const __m128i hba_msk = _mm_set_epi64x(0, UINT64_MAX);
> +
>         rxdp = rxq->rx_ring + rxq->rxrearm_start;
> 
>         /* Pull 'n' more MBUFs into the software ring */ @@ -108,6 +110,9 @@
> ixgbe_rxq_rearm(struct ixgbe_rx_queue *rxq)
>                 dma_addr0 = _mm_add_epi64(dma_addr0, hdr_room);
>                 dma_addr1 = _mm_add_epi64(dma_addr1, hdr_room);
> 
> +               dma_addr0 =  _mm_and_si128(dma_addr0, hba_msk);
> +               dma_addr1 =  _mm_and_si128(dma_addr1, hba_msk);
> +
>                 /* flush desc with pa dma_addr */
>                 _mm_store_si128((__m128i *)&rxdp++->read, dma_addr0);
>                 _mm_store_si128((__m128i *)&rxdp++->read, dma_addr1);
> bash-4.2$ cat patch1 diff --git a/drivers/net/ixgbe/ixgbe_rxtx.c
> b/drivers/net/ixgbe/ixgbe_rxtx.c index a0c8847..94967c5 100644
> --- a/drivers/net/ixgbe/ixgbe_rxtx.c
> +++ b/drivers/net/ixgbe/ixgbe_rxtx.c
> @@ -1183,7 +1183,7 @@ ixgbe_rx_alloc_bufs(struct ixgbe_rx_queue *rxq, bool
> reset_mbuf)
> 
>                 /* populate the descriptors */
>                 dma_addr =
> rte_cpu_to_le_64(RTE_MBUF_DATA_DMA_ADDR_DEFAULT(mb));
> -               rxdp[i].read.hdr_addr = dma_addr;
> +               rxdp[i].read.hdr_addr = 0;
>                 rxdp[i].read.pkt_addr = dma_addr;
>         }
> 
> @@ -1414,7 +1414,7 @@ ixgbe_recv_pkts(void *rx_queue, struct rte_mbuf
> **rx_pkts,
>                 rxe->mbuf = nmb;
>                 dma_addr =
> 
> rte_cpu_to_le_64(RTE_MBUF_DATA_DMA_ADDR_DEFAULT(nmb));
> -               rxdp->read.hdr_addr = dma_addr;
> +               rxdp->read.hdr_addr = 0;
>                 rxdp->read.pkt_addr = dma_addr;
> 
>                 /*
> @@ -1741,7 +1741,7 @@ next_desc:
>                         rxe->mbuf = nmb;
> 
>                         rxm->data_off = RTE_PKTMBUF_HEADROOM;
> -                       rxdp->read.hdr_addr = dma;
> +                       rxdp->read.hdr_addr = 0;
>                         rxdp->read.pkt_addr = dma;
>                 } else
>                         rxe->mbuf = NULL; @@ -3633,7 +3633,7 @@
> ixgbe_alloc_rx_queue_mbufs(struct ixgbe_rx_queue *rxq)
>                 dma_addr =
> 
> rte_cpu_to_le_64(RTE_MBUF_DATA_DMA_ADDR_DEFAULT(mbuf));
>                 rxd = &rxq->rx_ring[i];
> -               rxd->read.hdr_addr = dma_addr;
> +               rxd->read.hdr_addr = 0;
>                 rxd->read.pkt_addr = dma_addr;
>                 rxe[i].mbuf = mbuf;
>         }
> diff --git a/drivers/net/ixgbe/ixgbe_rxtx_vec.c
> b/drivers/net/ixgbe/ixgbe_rxtx_vec.c
> index 6c1647e..16a9c64 100644
> --- a/drivers/net/ixgbe/ixgbe_rxtx_vec.c
> +++ b/drivers/net/ixgbe/ixgbe_rxtx_vec.c
> @@ -56,6 +56,8 @@ ixgbe_rxq_rearm(struct ixgbe_rx_queue *rxq)
>                         RTE_PKTMBUF_HEADROOM);
>         __m128i dma_addr0, dma_addr1;
> 
> +       const __m128i hba_msk = _mm_set_epi64x(0, UINT64_MAX);
> +
>         rxdp = rxq->rx_ring + rxq->rxrearm_start;
> 
>         /* Pull 'n' more MBUFs into the software ring */ @@ -108,6 +110,9 @@
> ixgbe_rxq_rearm(struct ixgbe_rx_queue *rxq)
>                 dma_addr0 = _mm_add_epi64(dma_addr0, hdr_room);
>                 dma_addr1 = _mm_add_epi64(dma_addr1, hdr_room);
> 
> +               dma_addr0 =  _mm_and_si128(dma_addr0, hba_msk);
> +               dma_addr1 =  _mm_and_si128(dma_addr1, hba_msk);
> +
>                 /* flush desc with pa dma_addr */
>                 _mm_store_si128((__m128i *)&rxdp++->read, dma_addr0);
>                 _mm_store_si128((__m128i *)&rxdp++->read, dma_addr1);


More information about the dev mailing list