[dpdk-dev] KNI with multiple kthreads per port

Zhang, Helin helin.zhang at intel.com
Thu Mar 5 06:40:41 CET 2015



> -----Original Message-----
> From: dev [mailto:dev-bounces at dpdk.org] On Behalf Of JP M.
> Sent: Sunday, March 1, 2015 6:40 AM
> To: dev at dpdk.org
> Subject: [dpdk-dev] KNI with multiple kthreads per port
> 
> Howdy! First time posting; please be gentle. :-)
> 
> Environment:
>  * DPDK 1.8.0 release
>  * Linux kernel 3.0.3x-ish
>  * 32-bit (yes, KNI works fine, after a few tweaks hugepage init strategy)
Interesting! How did you get it works?

> 
> I'm trying to use the KNI example app with a configuration where multiple
> kthreads are created for a physical port. Per the user guide and code, the first
> such kthread is the "master", any the only one configurable; I'll refer to the
> additional kthread(s) as "slaves", although their relationship to the master
> kthread isn't discussed anywhere that I've looked thus far.
> 
> # insmod rte_kni.ko kthread_mode=multiple # kni [....] --config="(0,0,1,2,3)"
> # ifconfig vEth0_0 10.0.0.1 netmask 255.255.255.0
> 
> From the above: PMD-bound physical port0. Rx/Tx on cores 0 and 1,
> respectively. Master thread on core 2, one slave kthread on core 3.  Upon
> startup, KNI devices vEth0_0 (master) and vEth0_1 (slave) are created.
> After ifconfig, vEth0_0 works fine; by design, vEth0_1 cannot be configured.
What do you mean "vEth0_1 cannot be configured"?

> 
> The problem I'm encountering is that the subset of packets hitting vEth0_1 are
> being dropped... somewhere.  They're definitely getting as far as the call to
> netif_rx(skb).  I'll try on a newer system for comparison.  But before I go too
> much further, I'd like to establish the correct set-up and expectations.
So you can check the receiving side in KNI kernel function.

> 
> Should I be bonding vEth0_0 and vEth0_1?  Because I tried doing so (via sysfs);
> however, attempts to add either as slaves to bond0 were ignored.
What do you mean bonding here? Basically KNI has no relationship to bonding.

> 
> Any ideas appreciated. (Though it may end up being a moot point, with the
> other work this past week on KNI performance.)


More information about the dev mailing list