[dpdk-dev] [PATCH 1/4] ixgbe: rearrange vector PMD code for x86

[Bruce Richardson]

On Wed, Apr 20, 2016 at 09:44:59PM +0800, Jianbo Liu wrote:
> move SSE-dependent code to new file "ixgbe_rxtx_vec_sse.h"
> 
> Signed-off-by: Jianbo Liu <jianbo.liu at linaro.org>
> ---
>  drivers/net/ixgbe/ixgbe_rxtx_vec.c     | 369 +----------------------------
>  drivers/net/ixgbe/ixgbe_rxtx_vec_sse.h | 408 +++++++++++++++++++++++++++++++++
>  2 files changed, 409 insertions(+), 368 deletions(-)
>  create mode 100644 drivers/net/ixgbe/ixgbe_rxtx_vec_sse.h
> 
Hi Jianbo,

functionally I've given this a quick sanity test and see no issues with performance
on the x86(_64) side of things.

However, in terms of how the driver split in done in this set of patches, I think
it might be better to reverse what goes in the header files and in the .c files.
Rather than having the common code in the .c file and the arch specific code in
the header file, I think the common code should be in a header file and the
arch specific code in a .c file.

The reason for this is the need for possibly different compiler flags to be
passed for the vector drivers from the makefile e.g. as is done by my patchset
for i40e [http://dpdk.org/dev/patchwork/patch/12082/]. This would be a bit more
awkward if that one C file is shared by multiple architectures, as we'd have
architecture specific branches in both makefile and C file. As well as that,
the possibility exists of multiple vector drivers for one architecture, e.g.
an SSE and AVX driver for x86_64 with selection of code patch at runtime as done
by the ACL library. In that case, you want multiple vector code paths compiled
with different CFLAG overrides, which necessitates different C files.

Therefore, I think using a C file per instruction set/architecture, rather than
a header file per arch may be more expandable in future.

Regards,
/Bruce