[dpdk-dev] [PATCH v2 15/32] net/i40e: add VF vlan strip func

Ferruh Yigit ferruh.yigit at intel.com
Thu Dec 8 11:43:28 CET 2016


On 12/8/2016 9:10 AM, Chen, Jing D wrote:
> HI, Ferruh,
> 
> Best Regards,
> Mark
> 
> 
>> -----Original Message-----
>> From: Yigit, Ferruh
>> Sent: Wednesday, December 07, 2016 10:18 PM
>> To: Lu, Wenzhuo <wenzhuo.lu at intel.com>; dev at dpdk.org
>> Cc: Chen, Jing D <jing.d.chen at intel.com>
>> Subject: Re: [dpdk-dev] [PATCH v2 15/32] net/i40e: add VF vlan strip func
>>
>> On 12/7/2016 3:31 AM, Wenzhuo Lu wrote:
>>> Add a function to configure vlan strip enable/disable for specific
>>> SRIOV VF device.
>>>
>>> Signed-off-by: Chen Jing D(Mark) <jing.d.chen at intel.com>
>>> ---
>>
>> <...>
>>
>>> +
>>> +/* Set vlan strip on/off for specific VF from host */
>>> +int
>>> +rte_pmd_i40e_set_vf_vlan_stripq(uint8_t port, uint16_t vf_id, uint8_t on)
>>> +{
>>> +	struct rte_eth_dev *dev;
>>> +	struct i40e_pf *pf;
>>> +	struct i40e_vsi *vsi;
>>> +
>>> +	RTE_ETH_VALID_PORTID_OR_ERR_RET(port, -ENODEV);
>>> +
>>> +	dev = &rte_eth_devices[port];
>>> +	pf = I40E_DEV_PRIVATE_TO_PF(dev->data->dev_private);
>>> +
>>> +	if (vf_id > pf->vf_num - 1 || !pf->vfs) {
>>> +		PMD_DRV_LOG(ERR, "Invalid argument.");
>>> +		return -EINVAL;
>>> +	}
>>> +
>>> +	vsi = pf->vfs[vf_id].vsi;
>>> +
>>> +	if (vsi)
>>> +		return i40e_vsi_config_vlan_stripping(vsi, !!on);
>>> +	else
>>
>> if vd_if is valid, can vsi be NULL? If so this check may be required in
>> some prev patches too.
> 
> It's a little impossible. This sanity check just make the code stronger.
> 

If it is impossible, do you agree to remove this? And if this can be
possible we must update other patches, almost all other patches assume
this can't be NULL.


>>
>>> +		return -EINVAL;
>>> +}
>>> diff --git a/drivers/net/i40e/rte_pmd_i40e.h b/drivers/net/i40e/rte_pmd_i40e.h
>>> index ca5e05a..043ae62 100644
>>> --- a/drivers/net/i40e/rte_pmd_i40e.h
>>> +++ b/drivers/net/i40e/rte_pmd_i40e.h
>>> @@ -187,4 +187,24 @@ int rte_pmd_i40e_set_vf_multicast_promisc(uint8_t port,
>>>  int rte_pmd_i40e_set_vf_mac_addr(uint8_t port, uint16_t vf_id,
>>>  				 struct ether_addr *mac_addr);
>>>
>>> +/**
>>> + * Enable/Disable vf vlan strip for all queues in a pool
>>> + *
>>> + * @param port
>>> + *    The port identifier of the Ethernet device.
>>> + * @param vf
>>> + *    ID specifying VF.
>>> + * @param on
>>> + *    1 - Enable VF's vlan strip on RX queues.
>>> + *    0 - Disable VF's vlan strip on RX queues.
>>> + *
>>> + * @return
>>> + *   - (0) if successful.
>>> + *   - (-ENOTSUP) if hardware doesn't support this feature.
>>
>> Is this error type returned?
> 
> Good catch. Only -EINVAL and -ENODEV would be returned.
> 
>>
>>> + *   - (-ENODEV) if *port* invalid.
>>> + *   - (-EINVAL) if bad parameter.
>>> + */
>> <...>



More information about the dev mailing list