[dpdk-dev] [PATCH v3] bond: inherit maximum rx packet length

Bruce Richardson bruce.richardson at intel.com
Mon Jun 20 18:38:59 CEST 2016


On Fri, Jun 17, 2016 at 03:30:03PM +0100, Declan Doherty wrote:
> On 07/05/16 04:45, Eric Kinzie wrote:
> >  Instead of a hard-coded maximum receive length, allow the bond interface
> >  to inherit this limit from the slave interfaces.  This allows
> >  an application that uses jumbo frames to pass realistic values to
> >  rte_eth_dev_configure without causing an error.
> >
> >  Before the bond interface is configured, allow slaves with any
> >  max_rx_pktlen to be added and remember the lowest of these values as
> >  a candidate value.  During dev_configure, set the bond device's
> >  max_rx_pktlen to the candidate value.  After this point only slaves
> >  with a max_rx_pktlen greater or equal to that of the bonding device
> >  can be added.
> >
> >  If all slaves are removed, the bond device's pktlen is cleared.
> >
> >Signed-off-by: Eric Kinzie <ehkinzie at gmail.com>
> >---
> >
> ....
> >
> 
> Acked-by: Declan Dohetry <declan.doherty at intel.com>

Applied to dpdk-next-net/rel_16_07, with one checkpatch fix and with title
corrected to pass check with check-git-log.sh

/Bruce


More information about the dev mailing list