[dpdk-dev] [PATCH v2] i40e: fix ipv6 TSO issue for tx function

Zhe Tao zhe.tao at intel.com
Thu Mar 31 05:58:40 CEST 2016


On Thu, Mar 24, 2016 at 03:00:14PM +0000, Bruce Richardson wrote:
> On Wed, Mar 23, 2016 at 11:27:50AM +0800, Zhe Tao wrote:
> > Issue:
> > when using the following CLI in testpmd to enable ipv6 TSO feature
> > =============
> > set verbose 1
> > csum set ip hw 0
> > csum set udp hw 0
> > csum set tcp hw 0
> > csum set sctp hw 0
> > csum set outer-ip hw 0
> > csum parse_tunnel on 0
> > tso set 800 0
> > set fwd csum
> > 
> > start
> > =============
> 
> The "===" lines in the message are confusing patchwork. For a new version of
> this patch can you indent the commands rather than putting the "===" above and 
> below. E.g.
> 
>  Issue:
>  when using the following CLI in testpmd to enable ipv6 TSO feature
> 
>  	set verbose 1
>  	csum set ip hw 0
>  	csum set udp hw 0
> 	....
> 
> Thanks,
> /Bruce
very good advise, will send the new patch, thanks!
Zhe Tao


More information about the dev mailing list