[dpdk-dev] [PATCH v4 0/7] Change DPAA2 to dynamic logging
Thomas Monjalon
thomas at monjalon.net
Tue Apr 3 00:03:05 CEST 2018
02/04/2018 16:05, Shreyansh Jain:
> ::History::
> v4:
> - move CONFIG_RTE_LIBRTE_DPAA2_DEBUG_DRIVER to common_base
> - rebase over master (db2ed70bbb)
>
> v3:
> - Fixed review comments
> - one debug macro un-removed (CONFIG_RTE_LIBRTE_DPAA2_DEBUG_DRIVER)
> which is continued to be used by dpaa2 mempool driver
>
> v2:
> - Fixed dynamic log identifier names (Ferruh)
> - Added dependency information in cover letter (Hemant)
> - Fixed some checkpatch issues
> - Updated some log messages
>
> ::Dependency::
>
> This patchset is dependent on: master (acaa9ee991b)
>
> ::Introduction::
>
> DPAA2 devices are enabled by following modules:
> - bus/fslmc
> - net/dpaa2
> - mempool/dpaa2
> - event/dpaa2
> - crypto/dpaa2_sec
>
> This patch series converts the existing static debugging macros - for
> control and datapath, both - into dynamic logging macros.
Applied, thanks
More information about the dev
mailing list