[dpdk-dev] net/failsafe: add default Tx mbuf fast free capability

[Andrew Rybchenko]

On 12/21/18 3:12 PM, Ferruh Yigit wrote:
> On 10/12/2018 12:36 PM, Andrew Rybchenko wrote:
>> From: Ivan Malov <ivan.malov at oktetlabs.ru>
>>
>> This capability is reported when supported by the current emitting
>> sub-device. Failsafe PMD itself does not excercise fast free logic.
> I think overlay device capability reporting already discussed a few times, the
> question is if an overlay devices should claim a feature when it depends on
> underlay devices?

The capability may be reported by the failsafe since it is transparent from
fast free logic point of view.

> Given that no ack/review given to the patch, I am updating it as rejected.

Is it a new policy? I thought that it was vice versa before.

>> Signed-off-by: Ivan Malov <ivan.malov at oktetlabs.ru>
>> Signed-off-by: Andrew Rybchenko <arybchenko at solarflare.com>
>> ---
>>   doc/guides/nics/features/failsafe.ini | 1 +
>>   drivers/net/failsafe/failsafe_ops.c   | 1 +
>>   2 files changed, 2 insertions(+)
>>
>> diff --git a/doc/guides/nics/features/failsafe.ini b/doc/guides/nics/features/failsafe.ini
>> index e3c4c08f2..b6f3dcee6 100644
>> --- a/doc/guides/nics/features/failsafe.ini
>> +++ b/doc/guides/nics/features/failsafe.ini
>> @@ -7,6 +7,7 @@
>>   Link status          = Y
>>   Link status event    = Y
>>   Rx interrupt         = Y
>> +Fast mbuf free       = Y
>>   Queue start/stop     = Y
>>   Runtime Rx queue setup = Y
>>   Runtime Tx queue setup = Y
>> diff --git a/drivers/net/failsafe/failsafe_ops.c b/drivers/net/failsafe/failsafe_ops.c
>> index 7f8bcd4c6..e3add404b 100644
>> --- a/drivers/net/failsafe/failsafe_ops.c
>> +++ b/drivers/net/failsafe/failsafe_ops.c
>> @@ -78,6 +78,7 @@ static struct rte_eth_dev_info default_infos = {
>>   		DEV_RX_OFFLOAD_SECURITY,
>>   	.tx_offload_capa =
>>   		DEV_TX_OFFLOAD_MULTI_SEGS |
>> +		DEV_TX_OFFLOAD_MBUF_FAST_FREE |
>>   		DEV_TX_OFFLOAD_IPV4_CKSUM |
>>   		DEV_TX_OFFLOAD_UDP_CKSUM |
>>   		DEV_TX_OFFLOAD_TCP_CKSUM |
>>