[dpdk-dev] [PATCH 1/2] test/link_bonding: disable HW CRC strip by default.

[Phil Yang]

Since the tested virtual device has no capacity of HW CRC offload,
disable it for the link bonding test by default. Otherwise, it will
cause test unexpected failure.

Fixes: b219c8c("test: enable HW CRC strip by default")

Signed-off-by: Phil Yang <phil.yang at arm.com>
---
 test/test/test_link_bonding.c | 18 ++++--------------
 1 file changed, 4 insertions(+), 14 deletions(-)

diff --git a/test/test/test_link_bonding.c b/test/test/test_link_bonding.c
index 0ffd650..d996c02 100644
--- a/test/test/test_link_bonding.c
+++ b/test/test/test_link_bonding.c
@@ -137,14 +137,8 @@ static uint16_t vlan_id = 0x100;
 
 struct rte_eth_rxmode rx_mode = {
 	.max_rx_pkt_len = ETHER_MAX_LEN, /**< Default maximum frame length. */
-	.split_hdr_size = 0,
-	.header_split   = 0, /**< Header Split disabled. */
-	.hw_ip_checksum = 0, /**< IP checksum offload disabled. */
-	.hw_vlan_filter = 1, /**< VLAN filtering enabled. */
-	.hw_vlan_strip  = 1, /**< VLAN strip enabled. */
-	.hw_vlan_extend = 0, /**< Extended VLAN disabled. */
-	.jumbo_frame    = 0, /**< Jumbo Frame Support disabled. */
-	.hw_strip_crc   = 1, /**< CRC stripping by hardware enabled. */
+	.offloads = 0,
+	.ignore_offload_bitfield = 1,
 };
 
 struct rte_fdir_conf fdir_conf = {
@@ -158,12 +152,8 @@ static struct rte_eth_conf default_pmd_conf = {
 	.rxmode = {
 		.mq_mode = ETH_MQ_RX_NONE,
 		.max_rx_pkt_len = ETHER_MAX_LEN,
-		.split_hdr_size = 0,
-		.header_split   = 0, /**< Header Split disabled */
-		.hw_ip_checksum = 0, /**< IP checksum offload enabled */
-		.hw_vlan_filter = 0, /**< VLAN filtering disabled */
-		.jumbo_frame    = 0, /**< Jumbo Frame Support disabled */
-		.hw_strip_crc   = 1, /**< CRC stripped by hardware */
+		.offloads = 0,
+		.ignore_offload_bitfield = 1,
 	},
 	.txmode = {
 		.mq_mode = ETH_MQ_TX_NONE,
-- 
2.7.4