[dpdk-dev] [PATCH v4 2/3] net/mlx5: release port on close

Ophir Munk ophirmu at mellanox.com
Tue Oct 23 20:26:04 CEST 2018


With the introduction of representors several eth devices are using
the same rte device (e.g. a PCI bus). It is therefore required to
release the eth device resources during an eth device close operation
rather than during an rte device removal (detach) operation.
In current version many PMDs are still releasing the eth device as
part of the rte device removal. In order to allow a smooth transition
for all PMDs to behave correctly an ethdev flag RTE_ETH_DEV_CLOSE_REMOVE
is used. When this flag is set it indicates to rte_eth_dev_close() to
call rte_eth_dev_release_port(), so the port is freed during the close
operation.

Signed-off-by: Ophir Munk <ophirmu at mellanox.com>
---
v1-v3
This patch was not part of the serie

v4:
Initial version

 drivers/net/mlx5/mlx5.c | 11 +++++++++++
 1 file changed, 11 insertions(+)

diff --git a/drivers/net/mlx5/mlx5.c b/drivers/net/mlx5/mlx5.c
index 93b4057..7a8b45a 100644
--- a/drivers/net/mlx5/mlx5.c
+++ b/drivers/net/mlx5/mlx5.c
@@ -337,6 +337,17 @@
 	}
 	memset(priv, 0, sizeof(*priv));
 	priv->domain_id = RTE_ETH_DEV_SWITCH_DOMAIN_ID_INVALID;
+	/*
+	 * flag to rte_eth_dev_close() that it should release the port resources
+	 * (calling rte_eth_dev_release_port()) in addition to closing it.
+	 */
+	dev->data->dev_flags |= RTE_ETH_DEV_CLOSE_REMOVE;
+	/*
+	 * Reset mac_addrs to NULL such that it is not freed as part of
+	 * rte_eth_dev_release_port(). mac_addrs is part of dev_private so
+	 * it is freed when dev_private is freed.
+	 */
+	dev->data->mac_addrs = NULL;
 }
 
 const struct eth_dev_ops mlx5_dev_ops = {
-- 
1.8.3.1



More information about the dev mailing list