[dpdk-dev] [PATCH v2 04/11] examples/l3fwd: add ethdev setup based on eventdev

[Nipun Gupta]

> -----Original Message-----
> From: dev <dev-bounces at dpdk.org> On Behalf Of
> pbhagavatula at marvell.com
> Sent: Wednesday, December 4, 2019 8:14 PM
> To: jerinj at marvell.com; Marko Kovacevic <marko.kovacevic at intel.com>; Ori
> Kam <orika at mellanox.com>; Bruce Richardson
> <bruce.richardson at intel.com>; Radu Nicolau <radu.nicolau at intel.com>;
> Akhil Goyal <akhil.goyal at nxp.com>; Tomasz Kantecki
> <tomasz.kantecki at intel.com>; Sunil Kumar Kori <skori at marvell.com>;
> Pavan Nikhilesh <pbhagavatula at marvell.com>
> Cc: dev at dpdk.org
> Subject: [dpdk-dev] [PATCH v2 04/11] examples/l3fwd: add ethdev setup
> based on eventdev
> 
> From: Sunil Kumar Kori <skori at marvell.com>
> 
> Add ethernet port Rx/Tx queue setup for event device which are later
> used for setting up event eth Rx/Tx adapters.
> 
> Signed-off-by: Sunil Kumar Kori <skori at marvell.com>
> ---
>  examples/l3fwd/l3fwd.h       |  10 +++
>  examples/l3fwd/l3fwd_event.c | 129
> ++++++++++++++++++++++++++++++++++-
>  examples/l3fwd/l3fwd_event.h |   2 +-
>  examples/l3fwd/main.c        |  15 ++--
>  4 files changed, 144 insertions(+), 12 deletions(-)
> 

<snip>

> +
> +		local_port_conf.rx_adv_conf.rss_conf.rss_hf &=
> +
> 	dev_info.flow_type_rss_offloads;
> +		if (local_port_conf.rx_adv_conf.rss_conf.rss_hf !=
> +				port_conf->rx_adv_conf.rss_conf.rss_hf) {
> +			printf("Port %u modified RSS hash function "
> +			       "based on hardware support,"
> +			       "requested:%#"PRIx64"
> configured:%#"PRIx64"\n",
> +			       port_id,
> +			       port_conf->rx_adv_conf.rss_conf.rss_hf,
> +			       local_port_conf.rx_adv_conf.rss_conf.rss_hf);
> +		}

We are using 1 queue, but using RSS hash function?

> +
> +		ret = rte_eth_dev_configure(port_id, 1, 1, &local_port_conf);
> +		if (ret < 0)
> +			rte_exit(EXIT_FAILURE,
> +				 "Cannot configure device: err=%d,
> port=%d\n",
> +				 ret, port_id);
> +

We should be using number of RX queues as per the config option provided in the arguments.
L3fwd is supposed to support multiple queue. Right?

Regards,
Nipun