[dpdk-dev] ***Spam*** Re: Mempool handler ops index allocation issue

Andrew Rybchenko arybchenko at solarflare.com
Mon May 13 14:22:29 CEST 2019


Hi Olivier,

On 5/13/19 3:14 PM, Olivier Matz wrote:
> Hi Gage,
>
> On Thu, May 09, 2019 at 10:19:55PM +0000, Eads, Gage wrote:
>> Hi all,
>>
>> I ran into a problem with a multi-process application, in which two processes assigned the same mempool handler ops index to *different* handlers. This happened because the two processes supplied the -d EAL arguments in different order, e.g.:
>>
>> sudo ./appA -dlibrte_mempool_bucket.so -dlibrte_mempool_ring.so --proc-type primary &
>> sudo ./appB -dlibrte_mempool_ring.so -dlibrte_mempool_bucket.so --proc-type secondary &
>>
>> The dynamic load order matters because the ops indexes are assigned in the order the library ctors are run. This can result in the different processes trying to use different handlers for the same mempool.
>>
>> I'm not aware of any requirement that the EAL argument order should match across processes, so I don't think this is a user error. This could also happen in static libraries if they linked the libraries in a different order - but that shouldn't occur if both applications are following the rules for building an external application (https://doc.dpdk.org/guides/prog_guide/dev_kit_build_system.html#building-external-applications).
>>
>> If you agree that this is an issue, I see a couple possible resolutions:
>>
>>
>> 1.       Add a note/warning to the mempool handlers section of the user guide (https://doc.dpdk.org/guides/prog_guide/mempool_lib.html#mempool-handlers)
>>
>> 2.       Modify rte_mempool_register_ops() so that built-in handlers (ring, stack, etc.) have fixed IDs. E.g. ring is always 0, stack is always 1, etc. These handlers could be identified by their name string. User-registered mempools would still be susceptible to this problem, though.
>>
>> Thoughts? Alternatives?
> What about this:
>
> - add a new table in a named memory zone that stores the association
>    between mempool_ops id and name (but not the ops pointers) of the
>    primary process.
>
> - change rte_mempool_register_ops() to have a specific behavior in case
>    of a secondary process: lookup in that table to get the id associated
>    to the name (fail if not found).
>
>
> On the other hand, using secondary processes always looked a bit dangerous
> to me (for several reasons), so adding a note in the programmer's guide
> (your proposal 1) is also fine to me.

Suggested solution looks good to me.

Thanks,
Andrew.


More information about the dev mailing list