[dpdk-dev] [PATCH] net/ixgbe/base: wait for link after copper MAC setup
Ashijeet Acharya
ashijeet.acharya at 6wind.com
Fri May 24 11:30:15 CEST 2019
After setting up the link on x552/X557-AT 10GBASE-T NICs, sometimes the
link does not get set up properly and as a result all the subsequent
calls to ixgbe_check_link() from ixgbe_dev_link_update_share() fail.
Introduce a delay time of 1s in ixgbe_setup_mac_link_t_X550em() before
beginning to set up the external PHY link speed to ensure that the
controller can acquire the link.
Signed-off-by: Ashijeet Acharya <ashijeet.acharya at 6wind.com>
---
Hello,
This patch makes changes in the base driver.
Similar patch was introduced in case of fiber link MAC setup earlier
http://patchwork.dpdk.org/patch/43119/
Bugzilla: https://bugs.dpdk.org/show_bug.cgi?id=69
drivers/net/ixgbe/base/ixgbe_x550.c | 15 +++++++++++++++
1 file changed, 15 insertions(+)
diff --git a/drivers/net/ixgbe/base/ixgbe_x550.c b/drivers/net/ixgbe/base/ixgbe_x550.c
index a920a146e..930a61a20 100644
--- a/drivers/net/ixgbe/base/ixgbe_x550.c
+++ b/drivers/net/ixgbe/base/ixgbe_x550.c
@@ -4440,6 +4440,8 @@ s32 ixgbe_setup_mac_link_t_X550em(struct ixgbe_hw *hw,
{
s32 status;
ixgbe_link_speed force_speed;
+ u32 i;
+ bool link_up = false;
DEBUGFUNC("ixgbe_setup_mac_link_t_X550em");
@@ -4459,6 +4461,19 @@ s32 ixgbe_setup_mac_link_t_X550em(struct ixgbe_hw *hw,
if (status != IXGBE_SUCCESS)
return status;
+
+ /* Wait for the controller to acquire link */
+ for (i = 0; i < 10; i++) {
+ msec_delay(100);
+
+ status = ixgbe_check_link(hw, &force_speed, &link_up,
+ false);
+ if (status != IXGBE_SUCCESS)
+ return status;
+
+ if (link_up)
+ break;
+ }
}
return hw->phy.ops.setup_link_speed(hw, speed, autoneg_wait_to_complete);
--
2.11.0
More information about the dev
mailing list