[dpdk-dev] [PATCH v2] net/ixgbe: fix link status

[Cui LunyuanX]

After ports reset, tx laser register will be reset. The link
status for 82599eb got from link status register was not correct.
Set tx laser disabled after ports reset.

ixgbe_dev_setup_link_alarm_handler() will set tx laser enabled
when show port information. The purpose of the function has already
implemented in ixgbe_dev_start(). There is no need to reuse it
in ixgbe_dev_link_update_share().

Fixes: 0408f47ba4d6 ("net/ixgbe: fix busy polling while fiber link update")
Cc: stable at dpdk.org

Signed-off-by: Cui LunyuanX <lunyuanx.cui at intel.com>
---
 drivers/net/ixgbe/ixgbe_ethdev.c | 7 ++-----
 1 file changed, 2 insertions(+), 5 deletions(-)

diff --git a/drivers/net/ixgbe/ixgbe_ethdev.c b/drivers/net/ixgbe/ixgbe_ethdev.c
index 8c1caac18..5e516599c 100644
--- a/drivers/net/ixgbe/ixgbe_ethdev.c
+++ b/drivers/net/ixgbe/ixgbe_ethdev.c
@@ -1298,6 +1298,8 @@ eth_ixgbe_dev_init(struct rte_eth_dev *eth_dev, void *init_params __rte_unused)
 	/* enable support intr */
 	ixgbe_enable_intr(eth_dev);
 
+	ixgbe_dev_set_link_down(eth_dev);
+
 	/* initialize filter info */
 	memset(filter_info, 0,
 	       sizeof(struct ixgbe_filter_info));
@@ -4154,11 +4156,6 @@ ixgbe_dev_link_update_share(struct rte_eth_dev *dev,
 		link_up = 0;
 
 	if (link_up == 0) {
-		if (ixgbe_get_media_type(hw) == ixgbe_media_type_fiber) {
-			intr->flags |= IXGBE_FLAG_NEED_LINK_CONFIG;
-			rte_eal_alarm_set(10,
-				ixgbe_dev_setup_link_alarm_handler, dev);
-		}
 		return rte_eth_linkstatus_set(dev, &link);
 	}
 
-- 
2.17.1