[dpdk-dev] [PATCH] common/mlx5: fix user mode register access command

[Raslan Darawsheh]

Hi,

> -----Original Message-----
> From: Viacheslav Ovsiienko <viacheslavo at mellanox.com>
> Sent: Wednesday, July 29, 2020 3:29 PM
> To: dev at dpdk.org
> Cc: Matan Azrad <matan at mellanox.com>; Raslan Darawsheh
> <rasland at mellanox.com>; Dekel Peled <dekelp at mellanox.com>
> Subject: [PATCH] common/mlx5: fix user mode register access command
> 
> To detect the timestamp mode configured on the NIC the mlx5
> PMD uses the firmware command ACCESS_REGISTER_USER. This
> command is relatively new and might be not supported by
> older firmware versions and was rejected, causing annoying
> messages in kernel log.
> 
> This patch adds the attribute flag check whether firmware
> supports the command and avoid the call if it does not.
> 
> Fixes: bb7ef9a96281 ("common/mlx5: add register access DevX routine")
> 
> Signed-off-by: Viacheslav Ovsiienko <viacheslavo at mellanox.com>
> ---
>  drivers/common/mlx5/mlx5_devx_cmds.c | 2 ++
>  drivers/common/mlx5/mlx5_devx_cmds.h | 1 +
>  drivers/common/mlx5/mlx5_prm.h       | 3 ++-
>  drivers/net/mlx5/linux/mlx5_os.c     | 7 ++++---
>  4 files changed, 9 insertions(+), 4 deletions(-)
> 
> diff --git a/drivers/common/mlx5/mlx5_devx_cmds.c
> b/drivers/common/mlx5/mlx5_devx_cmds.c
> index d1c674c..7c81ae1 100644
> --- a/drivers/common/mlx5/mlx5_devx_cmds.c
> +++ b/drivers/common/mlx5/mlx5_devx_cmds.c
> @@ -688,6 +688,8 @@ struct mlx5_devx_obj *
>  			relaxed_ordering_write);
>  	attr->relaxed_ordering_read = MLX5_GET(cmd_hca_cap, hcattr,
>  			relaxed_ordering_read);
> +	attr->access_register_user = MLX5_GET(cmd_hca_cap, hcattr,
> +			access_register_user);
>  	attr->eth_net_offloads = MLX5_GET(cmd_hca_cap, hcattr,
>  					  eth_net_offloads);
>  	attr->eth_virt = MLX5_GET(cmd_hca_cap, hcattr, eth_virt);
> diff --git a/drivers/common/mlx5/mlx5_devx_cmds.h
> b/drivers/common/mlx5/mlx5_devx_cmds.h
> index 528cb7b..1c84cea 100644
> --- a/drivers/common/mlx5/mlx5_devx_cmds.h
> +++ b/drivers/common/mlx5/mlx5_devx_cmds.h
> @@ -93,6 +93,7 @@ struct mlx5_hca_attr {
>  	uint32_t vhca_id:16;
>  	uint32_t relaxed_ordering_write:1;
>  	uint32_t relaxed_ordering_read:1;
> +	uint32_t access_register_user:1;
>  	uint32_t wqe_index_ignore:1;
>  	uint32_t cross_channel:1;
>  	uint32_t non_wire_sq:1; /* SQ with non-wire ops is supported. */
> diff --git a/drivers/common/mlx5/mlx5_prm.h
> b/drivers/common/mlx5/mlx5_prm.h
> index 62efa72..0fa42bb 100644
> --- a/drivers/common/mlx5/mlx5_prm.h
> +++ b/drivers/common/mlx5/mlx5_prm.h
> @@ -1104,7 +1104,8 @@ struct mlx5_ifc_cmd_hca_cap_bits {
>  	u8 log_max_eq_sz[0x8];
>  	u8 relaxed_ordering_write[0x1];
>  	u8 relaxed_ordering_read[0x1];
> -	u8 log_max_mkey[0x6];
> +	u8 access_register_user[0x1];
> +	u8 log_max_mkey[0x5];
>  	u8 reserved_at_f0[0x8];
>  	u8 dump_fill_mkey[0x1];
>  	u8 reserved_at_f9[0x3];
> diff --git a/drivers/net/mlx5/linux/mlx5_os.c
> b/drivers/net/mlx5/linux/mlx5_os.c
> index fa3b027..c0d5325 100644
> --- a/drivers/net/mlx5/linux/mlx5_os.c
> +++ b/drivers/net/mlx5/linux/mlx5_os.c
> @@ -1067,9 +1067,10 @@
>  	if (config->devx) {
>  		uint32_t reg[MLX5_ST_SZ_DW(register_mtutc)];
> 
> -		err = mlx5_devx_cmd_register_read
> -			(sh->ctx, MLX5_REGISTER_ID_MTUTC, 0,
> -			reg, MLX5_ST_SZ_DW(register_mtutc));
> +		err = config->hca_attr.access_register_user ?
> +			mlx5_devx_cmd_register_read
> +				(sh->ctx, MLX5_REGISTER_ID_MTUTC, 0,
> +				reg, MLX5_ST_SZ_DW(register_mtutc)) :
> ENOTSUP;
>  		if (!err) {
>  			uint32_t ts_mode;
> 
> --
> 1.8.3.1


Patch applied to next-net-mlx,

Kindest regards,
Raslan Darawsheh