[dpdk-dev] [PATCH v1 08/12] net/ice: add queue config in DCF

Ye Xiaolong xiaolong.ye at intel.com
Sun Jun 7 12:11:22 CEST 2020


On 06/05, Ting Xu wrote:
>From: Qi Zhang <qi.z.zhang at intel.com>
>
>Add queues and Rx queue irqs configuration during device start
>in DCF. The setup is sent to PF via virtchnl.
>
>Signed-off-by: Qi Zhang <qi.z.zhang at intel.com>
>---
> drivers/net/ice/ice_dcf.c        | 109 +++++++++++++++++++++++++++
> drivers/net/ice/ice_dcf.h        |   6 ++
> drivers/net/ice/ice_dcf_ethdev.c | 125 +++++++++++++++++++++++++++++++
> 3 files changed, 240 insertions(+)
>
>diff --git a/drivers/net/ice/ice_dcf.c b/drivers/net/ice/ice_dcf.c
>index 8d078163e..d864ae894 100644
>--- a/drivers/net/ice/ice_dcf.c
>+++ b/drivers/net/ice/ice_dcf.c
>@@ -24,6 +24,7 @@
> #include <rte_dev.h>
> 
> #include "ice_dcf.h"
>+#include "ice_rxtx.h"
> 
> #define ICE_DCF_AQ_LEN     32
> #define ICE_DCF_AQ_BUF_SZ  4096
>@@ -831,3 +832,111 @@ ice_dcf_init_rss(struct ice_dcf_hw *hw)
> 
> 	return 0;
> }
>+
>+#define IAVF_RXDID_LEGACY_1 1
>+#define IAVF_RXDID_COMMS_GENERIC 16
>+
>+int
>+ice_dcf_configure_queues(struct ice_dcf_hw *hw)
>+{
>+	struct ice_rx_queue **rxq =
>+		(struct ice_rx_queue **)hw->eth_dev->data->rx_queues;
>+	struct ice_tx_queue **txq =
>+		(struct ice_tx_queue **)hw->eth_dev->data->tx_queues;
>+	struct virtchnl_vsi_queue_config_info *vc_config;
>+	struct virtchnl_queue_pair_info *vc_qp;
>+	struct dcf_virtchnl_cmd args;
>+	uint16_t i, size;
>+	int err;
>+
>+	size = sizeof(*vc_config) +
>+	       sizeof(vc_config->qpair[0]) * hw->num_queue_pairs;
>+	vc_config = rte_zmalloc("cfg_queue", size, 0);
>+	if (!vc_config)
>+		return -ENOMEM;
>+
>+	vc_config->vsi_id = hw->vsi_res->vsi_id;
>+	vc_config->num_queue_pairs = hw->num_queue_pairs;
>+
>+	for (i = 0, vc_qp = vc_config->qpair;
>+	     i < hw->num_queue_pairs;
>+	     i++, vc_qp++) {
>+		vc_qp->txq.vsi_id = hw->vsi_res->vsi_id;
>+		vc_qp->txq.queue_id = i;
>+		if (i < hw->eth_dev->data->nb_tx_queues) {
>+			vc_qp->txq.ring_len = txq[i]->nb_tx_desc;
>+			vc_qp->txq.dma_ring_addr = txq[i]->tx_ring_dma;
>+		}
>+		vc_qp->rxq.vsi_id = hw->vsi_res->vsi_id;
>+		vc_qp->rxq.queue_id = i;
>+		vc_qp->rxq.max_pkt_size = rxq[i]->max_pkt_len;
>+		if (i < hw->eth_dev->data->nb_rx_queues) {

What about changing as below to reduce the nested level of if blocks.

		if (i >= hw->eth_dev->data->nb_rx_queues)
			break;

		vc_qp->rxq.ring_len = rxq[i]->nb_rx_desc;
		vc_qp->rxq.dma_ring_addr = rxq[i]->rx_ring_dma;
		vc_qp->rxq.databuffer_size = rxq[i]->rx_buf_len;

		...
		}

>+			vc_qp->rxq.ring_len = rxq[i]->nb_rx_desc;
>+			vc_qp->rxq.dma_ring_addr = rxq[i]->rx_ring_dma;
>+			vc_qp->rxq.databuffer_size = rxq[i]->rx_buf_len;
>+
>+			if (hw->vf_res->vf_cap_flags &
>+			    VIRTCHNL_VF_OFFLOAD_RX_FLEX_DESC &&
>+			    hw->supported_rxdid &
>+			    BIT(IAVF_RXDID_COMMS_GENERIC)) {
>+				vc_qp->rxq.rxdid = IAVF_RXDID_COMMS_GENERIC;
>+				PMD_DRV_LOG(NOTICE, "request RXDID == %d in "

[snip]

>+static inline uint16_t
>+iavf_calc_itr_interval(int16_t interval)
>+{
>+	if (interval < 0 || interval > IAVF_QUEUE_ITR_INTERVAL_MAX)
>+		interval = IAVF_QUEUE_ITR_INTERVAL_DEFAULT;
>+
>+	/* Convert to hardware count, as writing each 1 represents 2 us */
>+	return interval / 2;
>+}
>+
>+static int ice_dcf_config_rx_queues_irqs(struct rte_eth_dev *dev,
>+				     struct rte_intr_handle *intr_handle)

put the return type in a separate line.

>+{
>+	struct ice_dcf_adapter *adapter = dev->data->dev_private;
>+	struct ice_dcf_hw *hw = &adapter->real_hw;
>+	uint16_t interval, i;
>+	int vec;
>+
>+	if (rte_intr_cap_multiple(intr_handle) &&
>+	    dev->data->dev_conf.intr_conf.rxq) {
>+		if (rte_intr_efd_enable(intr_handle, dev->data->nb_rx_queues))
>+			return -1;
>+	}
>+
>+	if (rte_intr_dp_is_en(intr_handle) && !intr_handle->intr_vec) {
>+		intr_handle->intr_vec =
>+			rte_zmalloc("intr_vec",
>+				    dev->data->nb_rx_queues * sizeof(int), 0);
>+		if (!intr_handle->intr_vec) {
>+			PMD_DRV_LOG(ERR, "Failed to allocate %d rx intr_vec",
>+				    dev->data->nb_rx_queues);
>+			return -1;
>+		}
>+	}
>+
>+	if (!dev->data->dev_conf.intr_conf.rxq ||
>+	    !rte_intr_dp_is_en(intr_handle)) {
>+		/* Rx interrupt disabled, Map interrupt only for writeback */
>+		hw->nb_msix = 1;
>+		if (hw->vf_res->vf_cap_flags &
>+		    VIRTCHNL_VF_OFFLOAD_WB_ON_ITR) {
>+			/* If WB_ON_ITR supports, enable it */
>+			hw->msix_base = IAVF_RX_VEC_START;
>+			IAVF_WRITE_REG(&hw->avf,
>+				       IAVF_VFINT_DYN_CTLN1(hw->msix_base - 1),
>+				       IAVF_VFINT_DYN_CTLN1_ITR_INDX_MASK |
>+				       IAVF_VFINT_DYN_CTLN1_WB_ON_ITR_MASK);
>+		} else {
>+			/* If no WB_ON_ITR offload flags, need to set
>+			 * interrupt for descriptor write back.
>+			 */
>+			hw->msix_base = IAVF_MISC_VEC_ID;
>+
>+			/* set ITR to max */
>+			interval =
>+			iavf_calc_itr_interval(IAVF_QUEUE_ITR_INTERVAL_MAX);
>+			IAVF_WRITE_REG(&hw->avf, IAVF_VFINT_DYN_CTL01,
>+				       IAVF_VFINT_DYN_CTL01_INTENA_MASK |
>+				       (IAVF_ITR_INDEX_DEFAULT <<
>+					IAVF_VFINT_DYN_CTL01_ITR_INDX_SHIFT) |
>+				       (interval <<
>+					IAVF_VFINT_DYN_CTL01_INTERVAL_SHIFT));
>+		}
>+		IAVF_WRITE_FLUSH(&hw->avf);
>+		/* map all queues to the same interrupt */
>+		for (i = 0; i < dev->data->nb_rx_queues; i++)
>+			hw->rxq_map[hw->msix_base] |= 1 << i;
>+	} else {
>+		if (!rte_intr_allow_others(intr_handle)) {
>+			hw->nb_msix = 1;
>+			hw->msix_base = IAVF_MISC_VEC_ID;
>+			for (i = 0; i < dev->data->nb_rx_queues; i++) {
>+				hw->rxq_map[hw->msix_base] |= 1 << i;
>+				intr_handle->intr_vec[i] = IAVF_MISC_VEC_ID;
>+			}
>+			PMD_DRV_LOG(DEBUG,
>+				    "vector %u are mapping to all Rx queues",
>+				    hw->msix_base);
>+		} else {
>+			/* If Rx interrupt is reuquired, and we can use
>+			 * multi interrupts, then the vec is from 1
>+			 */
>+			hw->nb_msix = RTE_MIN(hw->vf_res->max_vectors,
>+					      intr_handle->nb_efd);
>+			hw->msix_base = IAVF_MISC_VEC_ID;
>+			vec = IAVF_MISC_VEC_ID;
>+			for (i = 0; i < dev->data->nb_rx_queues; i++) {
>+				hw->rxq_map[vec] |= 1 << i;
>+				intr_handle->intr_vec[i] = vec++;
>+				if (vec >= hw->nb_msix)
>+					vec = IAVF_RX_VEC_START;
>+			}
>+			PMD_DRV_LOG(DEBUG,
>+				    "%u vectors are mapping to %u Rx queues",
>+				    hw->nb_msix, dev->data->nb_rx_queues);
>+		}
>+	}
>+
>+	if (ice_dcf_config_irq_map(hw)) {
>+		PMD_DRV_LOG(ERR, "config interrupt mapping failed");
>+		return -1;

Do we need to free intr_handle->intr_vec here?

>+	}
>+	return 0;
>+}
>+
> static int
> ice_dcf_dev_start(struct rte_eth_dev *dev)
> {
> 	struct ice_dcf_adapter *dcf_ad = dev->data->dev_private;
>+	struct rte_intr_handle *intr_handle = dev->intr_handle;
> 	struct ice_adapter *ad = &dcf_ad->parent;
> 	struct ice_dcf_hw *hw = &dcf_ad->real_hw;
> 	int ret;
>@@ -141,6 +254,18 @@ ice_dcf_dev_start(struct rte_eth_dev *dev)
> 		}
> 	}
> 
>+	ret = ice_dcf_configure_queues(hw);
>+	if (ret) {
>+		PMD_DRV_LOG(ERR, "Fail to config queues");
>+		return ret;
>+	}
>+
>+	ret = ice_dcf_config_rx_queues_irqs(dev, intr_handle);
>+	if (ret) {
>+		PMD_DRV_LOG(ERR, "Fail to config rx queues' irqs");
>+		return ret;
>+	}
>+
> 	dev->data->dev_link.link_status = ETH_LINK_UP;
> 
> 	return 0;
>-- 
>2.17.1
>


More information about the dev mailing list