[dpdk-dev] [PATCH 03/21] net/ixgbe/base: hange flow for "Apply Update" command

[Guinan Sun]

For the "Apply Update" command the firmware does not
given an response. For this command, success should
be return. Based on information at EAS.

Signed-off-by: Mateusz Kowalski <mateusz.kowalski at intel.com>
Signed-off-by: Guinan Sun <guinanx.sun at intel.com>
---
 drivers/net/ixgbe/base/ixgbe_common.c |  9 ++++++++-
 drivers/net/ixgbe/base/ixgbe_type.h   | 12 ++++++++++++
 2 files changed, 20 insertions(+), 1 deletion(-)

diff --git a/drivers/net/ixgbe/base/ixgbe_common.c b/drivers/net/ixgbe/base/ixgbe_common.c
index 9e3b71e38..89ae2b462 100644
--- a/drivers/net/ixgbe/base/ixgbe_common.c
+++ b/drivers/net/ixgbe/base/ixgbe_common.c
@@ -4584,11 +4584,18 @@ s32 ixgbe_hic_unlocked(struct ixgbe_hw *hw, u32 *buffer, u32 length,
 		msec_delay(1);
 	}
 
+	/* For each command except "Apply Update" perform
+	 * status checks in the HICR registry.
+	 */
+	if ((buffer[0] & IXGBE_HOST_INTERFACE_MASK_CMD) ==
+	    IXGBE_HOST_INTERFACE_APPLY_UPDATE_CMD)
+		return IXGBE_SUCCESS;
+
 	/* Check command completion */
 	if ((timeout && i == timeout) ||
 	    !(IXGBE_READ_REG(hw, IXGBE_HICR) & IXGBE_HICR_SV)) {
 		ERROR_REPORT1(IXGBE_ERROR_CAUTION,
-			     "Command has failed with no status valid.\n");
+			      "Command has failed with no status valid.\n");
 		return IXGBE_ERR_HOST_INTERFACE_COMMAND;
 	}
 
diff --git a/drivers/net/ixgbe/base/ixgbe_type.h b/drivers/net/ixgbe/base/ixgbe_type.h
index 0470b1dfc..33ca659cd 100644
--- a/drivers/net/ixgbe/base/ixgbe_type.h
+++ b/drivers/net/ixgbe/base/ixgbe_type.h
@@ -4366,4 +4366,16 @@ struct ixgbe_hw {
 #define IXGBE_NW_MNG_IF_SEL_MDIO_PHY_ADD	\
 				(0x1F << IXGBE_NW_MNG_IF_SEL_MDIO_PHY_ADD_SHIFT)
 
+/* Code Command (Flash I/F Interface) */
+#define IXGBE_HOST_INTERFACE_FLASH_READ_CMD			0x30
+#define IXGBE_HOST_INTERFACE_SHADOW_RAM_READ_CMD		0x31
+#define IXGBE_HOST_INTERFACE_FLASH_WRITE_CMD			0x32
+#define IXGBE_HOST_INTERFACE_SHADOW_RAM_WRITE_CMD		0x33
+#define IXGBE_HOST_INTERFACE_FLASH_MODULE_UPDATE_CMD		0x34
+#define IXGBE_HOST_INTERFACE_FLASH_BLOCK_EREASE_CMD		0x35
+#define IXGBE_HOST_INTERFACE_SHADOW_RAM_DUMP_CMD		0x36
+#define IXGBE_HOST_INTERFACE_FLASH_INFO_CMD			0x37
+#define IXGBE_HOST_INTERFACE_APPLY_UPDATE_CMD			0x38
+#define IXGBE_HOST_INTERFACE_MASK_CMD				0x000000FF
+
 #endif /* _IXGBE_TYPE_H_ */
-- 
2.17.1