[dpdk-dev] [PATCH 3/3 v3] app/testpmd: support hardware offload to drop error packets

nipun.gupta at nxp.com nipun.gupta at nxp.com
Fri Oct 9 15:13:31 CEST 2020


From: Nipun Gupta <nipun.gupta at nxp.com>

With DEV_RX_OFFLOAD_ERR_PKT_DROP now defined as an offload
capability, and separate DEV_RX_ERR_PKT_DROP_OFFLOAD_ALL capability
to drop all error packets in hardware, testpmd showcases this
with a new added configuration option 'enable-hw-drop-err-all'.

Signed-off-by: Nipun Gupta <nipun.gupta at nxp.com>
---
 app/test-pmd/parameters.c             | 7 +++++++
 app/test-pmd/testpmd.c                | 8 ++++++++
 app/test-pmd/testpmd.h                | 1 +
 doc/guides/testpmd_app_ug/run_app.rst | 4 ++++
 4 files changed, 20 insertions(+)

diff --git a/app/test-pmd/parameters.c b/app/test-pmd/parameters.c
index 1ead59579..508612426 100644
--- a/app/test-pmd/parameters.c
+++ b/app/test-pmd/parameters.c
@@ -142,6 +142,7 @@ usage(char* progname)
 	printf("  --enable-hw-vlan-strip: enable hardware vlan strip.\n");
 	printf("  --enable-hw-vlan-extend: enable hardware vlan extend.\n");
 	printf("  --enable-hw-qinq-strip: enable hardware qinq strip.\n");
+	printf("  --enable-hw-drop-err-all: enable hardware packet drop for all error packets.\n");
 	printf("  --enable-drop-en: enable per queue packet drop.\n");
 	printf("  --disable-rss: disable rss.\n");
 	printf("  --port-topology=<paired|chained|loop>: set port topology (paired "
@@ -631,6 +632,7 @@ launch_args_parse(int argc, char** argv)
 		{ "enable-hw-vlan-strip",       0, 0, 0 },
 		{ "enable-hw-vlan-extend",      0, 0, 0 },
 		{ "enable-hw-qinq-strip",       0, 0, 0 },
+		{ "enable-hw-drop-err-all",     0, 0, 0 },
 		{ "enable-drop-en",            0, 0, 0 },
 		{ "disable-rss",                0, 0, 0 },
 		{ "port-topology",              1, 0, 0 },
@@ -1283,6 +1285,11 @@ launch_args_parse(int argc, char** argv)
 				rmv_interrupt = 0;
 			if (!strcmp(lgopts[opt_idx].name, "flow-isolate-all"))
 				flow_isolate_all = 1;
+			if (!strcmp(lgopts[opt_idx].name,
+					"enable-hw-drop-err-all")) {
+				rx_err_pkt_drop_all = 1;
+			}
+
 			if (!strcmp(lgopts[opt_idx].name, "tx-offloads")) {
 				char *end = NULL;
 				n = strtoull(optarg, &end, 16);
diff --git a/app/test-pmd/testpmd.c b/app/test-pmd/testpmd.c
index ccba71c07..c9e7397e6 100644
--- a/app/test-pmd/testpmd.c
+++ b/app/test-pmd/testpmd.c
@@ -359,6 +359,11 @@ uint8_t lsc_interrupt = 1; /* enabled by default */
  */
 uint8_t rmv_interrupt = 1; /* enabled by default */
 
+/*
+ * Drop all RX error packets on HW itself.
+ */
+uint8_t rx_err_pkt_drop_all = 0; /* disabled by default */
+
 uint8_t hot_plug = 0; /**< hotplug disabled by default. */
 
 /* After attach, port setup is called on event or by iterator */
@@ -3359,6 +3364,9 @@ init_port_config(void)
 		    (rte_eth_devices[pid].data->dev_flags &
 		     RTE_ETH_DEV_INTR_RMV))
 			port->dev_conf.intr_conf.rmv = 1;
+
+		if (rx_err_pkt_drop_all)
+			port->dev_conf.err_pkt_drop_conf.all = 1;
 	}
 }
 
diff --git a/app/test-pmd/testpmd.h b/app/test-pmd/testpmd.h
index c7e7e41a9..eab154ed4 100644
--- a/app/test-pmd/testpmd.h
+++ b/app/test-pmd/testpmd.h
@@ -314,6 +314,7 @@ extern uint8_t no_device_start; /**<set by "--disable-device-start" parameter */
 extern volatile int test_done; /* stop packet forwarding when set to 1. */
 extern uint8_t lsc_interrupt; /**< disabled by "--no-lsc-interrupt" parameter */
 extern uint8_t rmv_interrupt; /**< disabled by "--no-rmv-interrupt" parameter */
+extern uint8_t rx_err_pkt_drop_all; /**< enabled by "--enable-hw-drop-err-all" parameter */
 extern uint32_t event_print_mask;
 /**< set by "--print-event xxxx" and "--mask-event xxxx parameters */
 extern bool setup_on_probe_event; /**< disabled by port setup-on iterator */
diff --git a/doc/guides/testpmd_app_ug/run_app.rst b/doc/guides/testpmd_app_ug/run_app.rst
index e2539f693..20f2f8083 100644
--- a/doc/guides/testpmd_app_ug/run_app.rst
+++ b/doc/guides/testpmd_app_ug/run_app.rst
@@ -213,6 +213,10 @@ The command line options are:
 
     Enable hardware QINQ strip.
 
+*  ``--enable-hw-drop-err-all``
+
+    Enable hardware packet drop for any error packets
+
 *   ``--enable-drop-en``
 
     Enable per-queue packet drop for packets with no descriptors.
-- 
2.17.1



More information about the dev mailing list