[dpdk-dev] [PATCH v8] app/testpmd: support multi-process

Ferruh Yigit ferruh.yigit at intel.com
Thu Apr 8 15:27:50 CEST 2021


On 4/8/2021 11:32 AM, Min Hu (Connor) wrote:
> Hi, Ferry and all,
>      This patch has been acked:
>      Acked-by: Xiaoyun Li <xiaoyun.li at intel.com>
>      Acked-by: Ajit Khaparde <ajit.khaparde at broadcom.com>
> 
>      Are there any other comments about that patch?
> 

Hi Connor,

In today's release status meeting I asked if more parties can test this patch,
Lets wait a little more for it to be tested.

> 
> 在 2021/3/30 18:43, Min Hu (Connor) 写道:
>>
>>
>> 在 2021/3/30 18:19, Ferruh Yigit 写道:
>>> On 3/30/2021 7:41 AM, Min Hu (Connor) wrote:
>>>>
>>>>
>>>> 在 2021/3/30 11:11, Ajit Khaparde 写道:
>>>>> On Mon, Mar 29, 2021 at 6:48 PM Min Hu (Connor) <humin29 at huawei.com> wrote:
>>>>>>
>>>>>> From: Lijun Ou <oulijun at huawei.com>
>>>>>>
>>>>>> This patch adds multi-process support for testpmd.
>>>>>> The test cmd example as follows:
>>>>>> the primary cmd:
>>>>>> ./dpdk-testpmd -a xxx --proc-type=auto -l 0-1 -- -i \
>>>>>> --rxq=4 --txq=4 --num-procs=2 --proc-id=0
>>>>>>
>>>>>> the secondary cmd:
>>>>>> ./dpdk-testpmd -a xxx --proc-type=auto -l 2-3 -- -i \
>>>>>> --rxq=4 --txq=4 --num-procs=2 --proc-id=1
>>>>>>
>>>>>> Signed-off-by: Min Hu (Connor) <humin29 at huawei.com>
>>>>>> Signed-off-by: Lijun Ou <oulijun at huawei.com>
>>>>> Some minor nits below. Otherwise looks fine to me.
>>>>> Acked-by: Ajit Khaparde <ajit.khaparde at broadcom.com>
>>>>>
>>>> Thanks Ajit.
>>>>
>>>> Hi, Ferruh,
>>>>      Should I send v9 to fix the grammar bugs in doc which Ajit point
>>>> out or fix it in future?
>>>>
>>>
>>> Hi Connor, if they are only outstanding issues, I can fix them while merging.
>>>
>> Thanks Ferruh.
>>>>>> ---
>>>>>> v8:
>>>>>> * Added warning info about queue numbers and process numbers.
>>>>>>
>>>>> :::snip::::
>>>>>
>>>>>> +*   ``--rxq=N``
>>>>>> +
>>>>>> +    Set the number of Rx queues per port to N. N is the sum of queues 
>>>>>> used by primary
>>>>>> +    and secondary process. Primary process and secondary process should 
>>>>>> have separate
>>>>>> +    queues, and each should occupy at least one queue. Where N should be 
>>>>>> the multiple
>>>>>> +    of number of processes.
>>>>> of the number of processes.
>>>>>
>>>>>> +
>>>>>> +*   ``--txq=N``
>>>>>> +
>>>>>> +    Set the number of Tx queues per port to N. N is the sum of queues 
>>>>>> used by primary
>>>>>> +    and secondary process. Primary process and secondary process should 
>>>>>> have separate
>>>>>> +    queues, and each should occupy at least one queue. Where N should be 
>>>>>> the multiple
>>>>>> +    of number of processes.
>>>>> of the number of processes.
>>>>>
>>>>>> +
>>>>>> +*   ``--num-procs=N``
>>>>>> +
>>>>>> +    The number of processes which will be used.
>>>>>> +
>>>>> :::: snip ::::
>>>>>> +The number of rings should be a multiple of the number of processes. If not,
>>>>>> +redundant queues will exist after queues are allocated to processes. 
>>>>>> After RSS is
>>>>>> +enabled, packet loss occurs when traffic is sent to all processes at the 
>>>>>> same time.
>>>>>> +Some traffic enters redundant queues and cannot be forwarded.
>>>>>> +
>>>>>> +Most dev ops is supported in primary and secondary process. While 
>>>>>> secondary process
>>>>> Most dev ops are supported in the primary and secondary process. While....
>>>>>
>>>>>> +is not permitted to allocate or release shared memory, so some ops are 
>>>>>> not supported
>>>>>> +as follows:
>>>>>> +``dev_configure``
>>>>>> +``dev_start``
>>>>>> +``dev_stop``
>>>>>> +``rx_queue_setup``
>>>>>> +``tx_queue_setup``
>>>>>> +``rx_queue_release``
>>>>>> +``tx_queue_release``
>>>>> :::: snip:::
>>>>>
>>>
>>> .
>> .



More information about the dev mailing list