[dpdk-dev] Questions about rte_eth_link_speed_to_str API

[Min Hu (Connor)]

Hi all,
	I have questions about rte_eth_link_speed_to_str API.
	The API converts link speed to string for display, But it only
supports the following speeds, like that:
	case ETH_SPEED_NUM_NONE: return "None";
	case ETH_SPEED_NUM_10M:  return "10 Mbps";
	case ETH_SPEED_NUM_100M: return "100 Mbps";
	case ETH_SPEED_NUM_1G:   return "1 Gbps";
	case ETH_SPEED_NUM_2_5G: return "2.5 Gbps";
	case ETH_SPEED_NUM_5G:   return "5 Gbps";
	case ETH_SPEED_NUM_10G:  return "10 Gbps";
	case ETH_SPEED_NUM_20G:  return "20 Gbps";
	case ETH_SPEED_NUM_25G:  return "25 Gbps";
	case ETH_SPEED_NUM_40G:  return "40 Gbps";
	case ETH_SPEED_NUM_50G:  return "50 Gbps";
	case ETH_SPEED_NUM_56G:  return "56 Gbps";
	case ETH_SPEED_NUM_100G: return "100 Gbps";
	case ETH_SPEED_NUM_200G: return "200 Gbps";
	case ETH_SPEED_NUM_UNKNOWN: return "Unknown";
	default: return "Invalid";

	In some cases, like bonding, for example, three slaves which
	link speed are 10Gbps, so link speed of bonding port will be
	30Gbps, but it shows "Invalid".

	Is this reasonable？ any comments will be welcome.

		Best wishes